Subtopic 5.3102 Equipment Installation

Proper installation and operation of new boiler

Flue gases removed safely and cost-efficiently

Pressure and temperature relief valve properly installed

Optimize boiler efficiency and prevent of short cycling

Varied distribution loop temperatures match seasonal heating load

Varied distribution loop temperatures match seasonal heating load

Automated redundant pump operation provides consistent heat to building

Improved pump efficiency and control

Electrical consumption reduced while matching water flow to demand

Installation of higher efficiency system

Optimized flow through all boilers

Optimized flow through all boilers

Accommodate the expansion and contraction of the system fluid

Allow for accommodation for the expansion and contraction of the system fluid

Fluid circulation

Insulation maintained on all mechanical equipment and piping that requires insulation

Safe management of flue gas condensate

Proper installation and operation of new boiler

Pressure relief valve properly installed

Optimize boiler efficiency and prevent short cycling

Increased efficiency of domestic hot water production

Tank heat loss reduced

Optimized boiler efficiency

Minimize cyclic boiler operation, increase system efficiency and boiler life

Compliance with Code Pre-Purge Requirement of Four Air Changes

Optimized efficiency and prevention of short cycling

Efficiencies safely maximized

Safe and optimal gas supply to all gas-fired equipment

Install Energy Management Systems

Accurate verification of system operating conditions

Established control of radiator heat output

Varied distribution loop flow to minimize pumping energy

Increased efficiency of domestic hot water ( DHW DHW Domestic hot water ) production

Increased efficiency of existing system

Prevent boiler from dry firing

Thermostat replaced when appropriate

Control quality and optimize performance and safety