|
The Dredge WHEELER
The hopper dredge WHEELER is operated by the New
Orleans District, U.S. Army Corps of Engineers. It is the largest hopper dredge in the
Corps of Engineers.
The WHEELER keeps waterway channels clear from
Key West, Florida, to Brownsville, Texas. Although the dredge is maintained in a state of readiness for
worldwide operations, it spends the majority of its time operating in the Southwest Pass of the
Mississippi River, dealing with shoaling problems that occur during high and low water.
The WHEELER is staffed with 38 civil service mariners. Crewmembers are divided into two operating tours,
alternating two weeks on/two weeks off, and weighted between full and skeleton manning. Their working
schedule consists of 10 and 12 hour days, including weekends. When underway, the dredge operates 24 hours
a day, 7 days a week. Every 14 days it docks for fuel, supplies, water, and engine maintenance
In compliance with recent legislation, the dredge is kept in a Ready Reserve status, capable of responding
to an urgent dredging requirement within three days. Periodic Readiness Exercises throughout the year keep
the crew and equipment prepared for these contingencies.
Dredging Operations
The WHEELER is a "trailing suction" hopper dredge. That is, it operates much like a giant vacuum cleaner.
It is uniquely designed with three large drag arms and an impressive pumping capacity. To dredge a channel,
the drag arms are lowered over the side to the channel bottom. While the WHEELER travels forward at a speed
of approximately 2 knots, the drag arms suck a water and sand mixture, known as slurry, from the channel bottom.
The slurry passes through the drag heads and pipelines into the hopper.
|
With all pumps and drag arms operating, the WHEELER fills its hopper with slurry in about 11 minutes; however, pumping
continues to allow sediment to displace the water in the hopper and obtain a maximum load of as much as 7,872 cubic
yards of sediment.
On a good operating day, the WHEELER can remove 100,000 cubic yards of material, or about 7,000 dumptruck loads,
from a project site.
The dredged material is transported from the channel being maintained to an authorized Dredge Material Containment
Area, where it is deposited by opening 14 hopper doors on the WHEELER's bottom and allowing the material to
fall to the ocean floor.
With all pumps and drag arms operating, the WHEELER fills its hopper with slurry in about 11 minutes; however, pumping continues to allow sediment to displace the water in the hopper and |
The bottom of one of the WHEELER's drag heads. |
obtain a maximum load of as much as 7,872 cubic yards of sediment.
On a good operating day, the WHEELER can remove 100,000 cubic yards of material, or about 7,000 dumptruck loads,
from a project site.
The dredged material is transported from the channel being maintained to an authorized Dredge Material Containment
Area, where it is deposited by opening 14 hopper doors on the WHEELER's bottom and allowing the material to
fall to the ocean floor.
THE U.S. DREDGE WHEELER
At a Glance
Drag arms
|
2 overside @ 28" diameter 1 centerwell @ 42" diamter |
Full load capacity |
8,256 cubic yards |
Overall length |
408 feet, 3 inches |
Height
(keel to top of mast) |
156 feet |
Loaded displacement |
19,030.9 L. tons |
Gross tonnage |
10,164 tons |
Loaded draft |
29 feet, 6 inches mean |
Propulsion |
Twin diesel with bowthruster |
Total horsepower |
10,400 main, 800 on bowthrusters |
Shafting |
Twin propeller, controllable pitch |
Top speed at full load |
14.4 knots |
Crew |
38 total, divided into 2 working tours |
Date Launched |
18 February 1981 |
Date placed in service |
17 September 1982 |
Contact
Raymond Newman, CEMVN-OD-YM
504-862-2050
Raymond.C.Newman@usace.army.mil
|