Recently a miner was seriously burned when the equipment he was operating caught fire. The operator hit the manual fire suppression actuator, but did not pull the pin. Thus, it did not actuate. There was no fire extinguisher in the cab and the operator was burned when he tried to get out by the normal egress route. He finally managed to get out on the opposite side.
The following suggestions may help avoid this situation:
- Training on fire suppression
systems should be given to operators of trucks, bulldozers and other
enclosed cab vehicles. A manual fire suppression actuator should be used
as a training tool in this effort, if it is utilized. Special emphasis
should be placed on activating the system in realistic conditions.
- All fire extinguishers and fire
suppression systems including alarms, shutdowns and other associated
equipment need to be thoroughly examined and periodically checked for
proper operation by competent personnel in accordance with the
manufacturer's recommended schedule. Any defective equipment needs to be
repaired, replaced, and the system retested for proper operation.
The manufacturer should be asked for their recommended maintenance
schedules.
- A small fire extinguisher
commensurate with the level of hazard should be located in the cab of all vehicles to be readily accessible to the operator. The fire extinguisher should be a Type ABC.
Proper training and maintenance of fire suppression systems can
reduce injuries and
fatalities. |
