Steven Jay Hagedorn is an MSHA Metal/Non Metal inspector. He writes:
I was inspecting a radial stacker. The belt was not running. I noted that an S/O power cable had damage to the outer jacket. Since the stacker was not running, I thought it was de-energized {WRONG}. The cable was supplying power to a disconnecting device in a branch circuit to the starter. The starter circuit is de-energized but the cable is still energized. I was so close to moving it to take a photo, but I stopped and checked the power cable. It Was HOT. I could have been dead or badly burned.
Steven carries a non-contact AC voltage detector on his inspections just for this purpose. This sensitive electrical sensor will signal when an electrical circuit is live in a conductor or even in the metal equipment frame. By determining if the power has been disconnected prior to touching an electrically powered machine or cable, Steven saved himself from a dangerous electrical shock, burn or even an electrocution. These devices are relatively inexpensive ($10 to $75) and are great for checking fuses, breaker panels, power outlets, cable splices, load break connectors, transmission lines, etc. The only drawback is that they do not detect DC current.
A search on the internet for a non-contact voltage detector will quickly list hundreds of suppliers who carry these devices. MSHA and Steven both believe they can be lifesavers.
MSHA note: Always assure:
- the testing device is rated for the circuit being tested
- properly rated electrical gloves are worn
- that the device is tested on a known live circuit prior to each use
MSHA extends a thank you and a tip of the hardhat to
Steven Hagedorn of Vacaville, CA.
a winner of a limited edition sticker and patch.
If you have a tip you would like to pass on, you can email it to zzMSHA-MinersTips@dol.gov. If your tip is selected, you will receive credit in this space. |
Issued: |
04/21/2009 |
Tag # |
AP0096083
|
|