Advisory Circulars
Airworthiness Standards: Transport Category Airplanes
Number | Office | Title | Date |
---|---|---|---|
25-7C | ANM-110 |
Flight Test Guide For Certification Of Transport Category Airplanes
This advisory circular (AC) provides guidance for the flight test evaluation of transport category airplanes. This AC includes flight test methods and procedures to show compliance with the regulations contained in subpart B of Title 14, Code of Federal Regulations (14 CFR) part 25, which address airplane performance and handling characteristics. This revision, AC 25-7C, is a complete revision to reduce the number of differences from the European Aviation Safety Agency’s Flight Test Guide, provide acceptable means of compliance for the regulatory changes associated with amendments 107, 109, 113, 115, 119, and 123 to part 25, respond to National Transportation Safety Board recommendations, and to provide a general update to reflect current FAA and industry practices and policies. |
10-16-2012 |
25.803-1A | ANM-115 |
Emergency Evacuation Demonstrations
This advisory circular (AC) provides guidance on means, but not the only means, of compliance with Title 14, Code of Federal Regulations (14 CFR) part 25 concerning: (1) conduct of full?scale emergency evacuation demonstrations, and (2) use of analysis and tests in lieu of conducting an actual demonstration. Throughout this AC, any reference to a full-scale demonstration, unless further qualified, means an evacuation demonstration in which a full complement of passengers and the requisite number of crewmembers evacuate an airplane using assist means, if installed, under the conditions specified in part 25, appendix J. References to “appendix J” means 14 CFR part 25, appendix J. Additionally, any reference to an analysis, which is to be used to satisfy the emergency evacuation requirements of part 25, means a formal analysis document supported by data from tests or demonstrations. Terms such as “shall” and “must” are used only in the sense of ensuring applicability of this particular means of compliance when the acceptable means of compliance described herein is used. |
03-12-2012 |
25-19A | ANM-117 |
Certification Maintenance Requirements
This advisory circular (AC) provides guidance on the selection, documentation, and control of Certification Maintenance Requirements (CMR). This AC also provides a rational basis for coordinating the Maintenance Review Board (MRB), if the MRB process is used, and CMR selection processes to ensure premises made in the system safety analyses supporting the compliance with the requirements of Title 14, Code of Federal Regulations (14 CFR) 25.1309, and other system safety rules (such as §§ 25.671, 25.783, 25.901, and 25.933) are protected in service. This AC describes an acceptable means, but not the only means, for selecting, documenting, and managing CMRs. Terms such as "shall" and "must" are used only in the sense of ensuring applicability of this particular means of compliance when the acceptable means of compliance described herein is used. |
10-03-2011 |
25.571-1D | ANM-115 |
Damage Tolerance and Fatigue Evaluation of Structure
This advisory circular (AC) provides guidanc~ for compliance with the provisions of Title 14, Code of Federal Regulations (14 CFR) part 25, pertaining to the requirements for damage-tolerance and fatigue evaluation oftransport category aircraft structurce, including evaluation of widespread fatigue dam, age (VlFD) and establishing a limit of validity of the engineering data that supports the structural-maintenance program (hereafter referred to as the LOV). |
01-13-2011 |
25.1322-1 | ANM-100 |
Flightcrew Alerting
This Advisory Circular (AC) provides guidance for showing compliance with certain requirements of Title 14 of the Code of Federal Regulations (14 CFR), part 25, for the design approval of flightcrew-alerting functions |
12-13-2010 |
25.1419-2 | ANM-110 |
Compliance with the Ice Protection Requirements of §§ 25.1419(e), (f), (g), and (h)
This advisory circular (AC) describes an acceptable means for showing compliance with the requirements of Title 14, Code of Federal Regulations (14 CFR), 25.1419(e), (f), (g), and (h), Ice protection. Part 25 contains the airworthiness standards applicable to transport category airplanes a. Installing a primary ice detection system; b. Developing visual cues and installing an advisory ice detection system to alert the flightcrew that the airframe ice protection system (IPS) must be activated; c. Identifying conditions conducive to airframe icing through the use of temperature and visible moisture cues; and d. Including in the airplane flight manual (AFM) procedures for activating and deactivating the airframe IPS. |
10-27-2009 |
25-17A | ANM-100 |
Transport Airplane Cabin Interiors Crashworthiness Handbook
This Advisory Circular (AC) provides acceptable certification methods, but not necessarily the only acceptable methods, for demonstrating compliance with the crashworthiness requirements of part 25, as amended through Amendment 25-112, of Title 14 of the Code of Federal Regulations (14 CFR) for transport category airplanes. The guidance in this AC is not mandatory nor a regulation. |
05-18-2009 |
25.795-1A | ANM-100 |
FlightDeck Intrusion Resistance
This advisory circular (AC) sets forth an acceptable means, but not the only means, of demonstrating compliance with the provisions of the airworthiness standards for transport category airplanes related to the airplane design for flightdeck (also referred to as the pilot compartment or cockpit) intrusion resistance. Intrusion resistance, in the context of this AC, refers to the ability to resist forced entry by a person who is not authorized by the pilot in command to enter the flightdeck. Intrusion resistance also includes the ability to resist attempts to enter the flightdeck through use of simple tools, such as pocket knives, nail files, or keys.
|
10-24-2008 |
25.795-2A | ANM-100 |
Flight Deck Penetration Resistance
This advisory circular (AC) sets forth an acceptable means, but not the only means, of demonstrating compliance with the provisions of the airworthiness standards for transport category airplanes related to the airplane design for flightdeck penetration resistance.
|
10-24-2008 |
25.795-3 | ANM-100 |
Flightdeck Protection (Smoke and Fumes)
This advisory circular (AC) describes an acceptable means of showing compliance with the requirements of Title 14, Code of Federal Regulations (14 CFR), part 25, § 25.795(b)(1), “Flight deck protection.” This section requires that an airplane be designed to limit the entry of smoke, fumes, and noxious gases into the flightdeck in the event of detonation of an explosive or incendiary device on the airplane. The means of compliance described in this document provides guidance to supplement the engineering and operational judgment that must form the basis of any compliance findings relative to penetration into the flightdeck of smoke, fumes, and noxious gases generated by explosions or fires elsewhere on the airplane.
|
10-24-2008 |
25.795-4 | ANM-100 |
Passenger Cabin Smoke Protection
This Advisory Circular (AC) provides an acceptable means of showing compliance with the requirements of Title 14, Code of Federal Regulations (CFR), part 25, § 25.795(b)(2), “Cabin smoke protection.” This section requires that an airplane be designed with means to prevent passengers from being incapacitated by smoke, fumes, and noxious gases that result from detonation of an explosive or incendiary device during flight. The means of compliance described in this document provides guidance to supplement the engineering and operational judgment that must form the basis of any compliance findings relative to penetration of smoke, fumes, and noxious gases into the passenger cabin.
|
10-24-2008 |
25.795-5 | ANM-100 |
Cargo Compartment Fire Suppression
This advisory circular (AC) describes an acceptable means for showing compliance with the requirements of Title 14, Code of Federal Regulations (14 CFR), part 25, § 25.795(b)(3), “Cargo compartment fire suppression.” This section requires that the fire suppression system for the cargo compartment be designed to withstand a sudden and extensive explosion and fire, such as could be caused by an explosive or incendiary device. The means of compliance described in this document provides guidance to supplement the engineering and operational judgment that must form the basis of any compliance findings relative to the design of fire suppression systems for the cargo compartment.
|
10-24-2008 |
25.795-6 | ANM-100 |
Least Risk Bomb Location
This advisory circular (AC) describes an acceptable means for showing compliance with the requirements of Title 14, Code of Federal Regulations (CFR), part 25, § 25.795(c), “Least risk bomb location.” This section requires that a location on the airplane be designed where an explosive or incendiary device may be placed to protect flight critical structures and systems from damage in case of detonation. The means of compliance described in this document provide guidance to supplement the engineering and operational judgment that must form the basis of any compliance findings relative to the design of a Least Risk Bomb Location on an airplane.
|
10-24-2008 |
25.795-7 | ANM-100 | Survivability of Systems | 10-24-2008 |
25.795-8 | ANM-100 |
Interior Design to Facillitate Searches
This advisory circular (AC) describes an acceptable means for showing compliance with the requirements of Title 14, Code of Federal Regulations (14 CFR), part 25, § 25.795(c)(3), “Interior design to facilitate searches.” This section requires that the interior design of an airplane incorporate features that will make it more difficult to hide dangerous objects in the airplane or make it easier to find them if they have been brought onboard. The means of compliance described in this document provides guidance to supplement the engineering and operational judgment that must form the basis of any compliance findings relative to whether the interior design deters concealment of dangerous objects (e.g., weapons or explosives) and facilitates a search for them in certain areas of the airplane. The requirements for searching an airplane are not affected by the requirements of § 25.795(c)(3). The design of the airplane will make it easier to search for hidden objects but will not affect the need for, or the diligence of, the search.
|
10-24-2008 |
25.981-1C | ANM-112 |
Fuel Tank Ignition Source Prevention Guidelines
This advisory circular provides guidance for demonstrating compliance with the certification requirements for prevention of ignition sources within the fuel tanks of transport category airplanes. This guidance is applicable to transport category airplanes for which a new, amended, or supplemental type certificate is requested.
|
09-19-2008 |
25.981-2A | ANM-112 |
Fuel Tank Flammability
This advisory circular (AC) provides information and guidance on compliance with the airworthiness standards for transport category airplanes about limiting the time a fuel tank may be flammable or mitigation of hazards from flammable fuel air mixtures within fuel tanks. This guidance is applicable to transport category airplanes for which a new, amended, or supplemental type certificate is requested, and for which Amendment 25-125 applies. It is also applicable to certain existing design approval holders and certain pending applications for new type certificates, supplemental type certificates and amended type certificates where required by §§ 26.33, 26.35, 26.37, and 26.39, contained in a subpart D to Title 14, Code of Federal Regulations (CFR) part 26, “Fuel Tank Flammability.” Guidance on compliance with the associated requirements for operators of affected airplanes that must comply with requirements in 14 CFR parts 121, 125 and 129, to incorporate flammability reduction or ignition mitigation means by specified dates, will be contained in a separate document.
|
09-19-2008 |
25.856-2A | ANM-115 | Installaiton of Thermal/Acoustic Insulation for Burnthrough Proctection | 07-29-2008 |
25.1701-1 | ANM-100 |
Certification of Electrical Wiring Interconnection Systems on Transport Category Airplanes
This Advisory Circular (AC) provides guidance for certification of electrical wiring interconnection systems (EWIS) on transport category airplanes in accordance with 14 CFR part 25, subpart H, sections §§25.1701 through 25.1739 and sections H25.4 and H25.5 of Appendix H to part 25.
|
12-04-2007 |
25.1365-1 | ANM-100 |
Electrical Appliances, Motors, and Transformers
This advisory circular (AC) provides guidance for demonstrating compliance with the transport category airplane certification requirements of § 25.1365 Electrical appliances, motors, and transformers.
|
11-27-2007 |
25.1529-1A | ANM-100 |
Instructions for Continued airworthiness of Structural Repairs on Transport Airplanes
Provides instructions to ensure continued airworthiness of structural repairs on transport category airplanes. It addresses the approval procedures to follow when making structural repairs to structure certificated under the damage tolerance requirements of Section 25.571 of FAR, Amendment 25-45, and to type designs with Supplemental Inspection Documents, which were based on these criteria.
|
11-20-2007 |
25-26 | ANM-100 | Development of standard wiring practices documentation | 11-14-2007 |
25-869.1A | ANM-110 | Fire Protection Systems | 10-22-2007 |
25.1353-1A | ANM-100 | Electrical equipment and installations | 10-22-2007 |
25.1357-1A | ANM-100 | Circuit protective devices | 10-22-2007 |