FSC 9310                                                         JCP R20
                                NEWSBOARD
Miscellaneous Board                                     February 1, 1999
--------------------------------------------------------------------------

Use information: This paragraph is informational only and is not 
    exclusively definitive of the end use.
  For backing of pads and tablets and top and bottom protection in 
packaging.

Stock: Not less than 80 pct postconsumer fiber. Any percent over 80 
  percentage points, is encouraged, provided that the requirements of 
  this Standard are met.

Grammage (g/m\2\)................................. 355
  Basis weight: 26 by 38 inches, 50 pounds 
(number).......................................... 100
  A tolerance of 5 pct shall be 
allowed.

Bursting strength: Average, not less than (kPa)... 340
  Equivalent (lb/in\2\)........................... 50

Thickness: Average (mm)........................... 0.51
  Equivalent (inch)............................... 0.020
    A tolerance of -0.03 mm (0.001 inch) and +0.05 mm (0.002 inch) shall 
  be allowed.
General appearance: The surface and cleanliness shall conform to the 
  standard sample(s) adopted by the Government.
Sampling and testing: Shall be conducted in accordance with standards in 
  Part 2, Government Paper Specification Standards.

------------------------------------------------------------------------

 Unless otherwise specified, the following is automatically waived when 
  printing or duplicating is to be accomplished on commercial contract
Curl: Paper board shall lie flat with either no tendency to curl or with 
  a curl which can be overcome under reasonable working conditions.
Size and trim: Paper board shall be furnished in the size(s) ordered and 
  shall be flat, trimmed square on four sides with clean smooth edges, 
  and evenly jogged. A tolerance of 2 mm (\1/16\ inch) shall 
  be allowed. Successive sheets within any package shall not differ from 
  each other by more than 0.5 mm (\1/64\ inch).

  Paper board with the long dimension 813 mm (32 inches) or less shall 
  be considered square if the variation does not exceed 1 mm (\1/32\ 
  inch); over 813 mm (32 inches), 2 mm (\1/16\ inch).

Pressroom conditions: The bulk of this paper board will be used in air-
  conditioned pressrooms maintained at 24  deg.C 2  deg.C 
  and 
  45 pct 8 pct relative humidity.