Additional Resources
Structural Collapses During Construction - Lessons Learned, 1990-2008 [PDF* - 544 KB]. OSHA investigated 96 structural collapses during construction involving fatalities and injuries from 1990 to 2008. The most probable causes of each of these incidents are summarized in this article, which was published in STRUCTURE magazine, December 2010. Construction errors contributed to 80% of the structural collapses while the remaining 20% of the incidents are attributed to structural design flaws on the part of either the structural engineer of record (SER) or a structural engineer retained by a contractor to design specific members. OSHA Construction Publications, Fact Sheets, QuickCards. Provides an alphabetical listing of OSHA publications, guidance documents, fact sheets, quickcards, posters, and more. These publications provide information from—detailed examinations of specific safety and health issues, basic background information on safety and health hazards, safety and health information for employers/employees—to safety guidance for employees and employers in specific industries. OSHA Construction Alliances. Provides a listing of signed alliances specific to construction, each providing information, guidance, and access to training resources that will help protect employees' health and safety. OSHA Safety and Health Topics. Provides access to selected occupational safety and health information. The subjects of these pages include information specific to construction workplace hazards. OSHA Susan Harwood Training Grant - Grantee Produced Training Materials. Provides training and education programs for workers and employers on the recognition, avoidance, abatement, and prevention of safety and health hazards in their workplaces through Susan Harwood Training Program grants. OSHA eTools
Construction. Construction can be a safe occupation when workers are aware of the hazards, and an effective Safety and Health Program is used. This eTool will help workers identify and control the hazards that commonly cause the most serious construction injuries. Ergonomics: Solutions for Electrical Contractors. Between 1999 and 2002, more than 30 percent of all workers' compensation claims from the Independent Electrical Contractors (IEC) were related to ergonomics. This amounted to more than $10 million in claims in just four years. This eTool describes common hazards that electrical contractors may encounter and possible solutions for these hazards. The eTool was developed in cooperation with IEC as part of the OSHA-IEC Alliance. Scaffolding. An estimated 2.3 million construction workers, or 65% of the construction industry, work on scaffolds frequently. Protecting these workers from scaffold-related accidents would prevent 4,500 injuries and 50 deaths every year, at a savings for American employers of $90 million in workdays not lost. These eTools provide illustrated examples of safe scaffolding safety. Hazards are identified, as well as the controls that keep those hazards from becoming tragedies. The Supported Scaffold and Suspended Scaffold modules are now available. Steel Erection. Despite being covered since 1971 under the original steel erection standard, America's 56,000 steel erectors continue to suffer 35 fatal accidents per year, a rate of one death per 1,600 workers. OSHA estimates that 30 of those deaths, as well as nearly 1,150 annual lost-workday injuries, will be averted by compliance with provisions of the new standard, developed with industry and labor through negotiated rulemaking. To that end, this eTool has been created to educate employers and workers about the revised standard (Subpart R). Expert Advisors Asbestos. This computer program is intended to provide an introduction to the scope and logic of the regulation for general industry, construction, and maritime. Accessibility Assistance: Contact the OSHA Directorate of Construction at 202-693-2020 for assistance accessing PDF and PPT materials. |