![](https://webarchive.library.unt.edu/web/20081105132531im_/http://ecfr.gpoaccess.gov/e/ecfr/images/spacer.gif) |
|
![](https://webarchive.library.unt.edu/web/20081105132531im_/http://www.gpoaccess.gov/images/spacer.gif) |
Home Page > Executive Branch > Code of Federal Regulations > Electronic Code of Federal Regulations
![blue pill](https://webarchive.library.unt.edu/web/20081105132531im_/http://ecfr.gpoaccess.gov/e/ecfr/images/logo--bluepill.gif)
e-CFR Data is current as of November 3, 2008
TITLE 40--Protection of Environment
CHAPTER I--ENVIRONMENTAL PROTECTION AGENCY
SUBCHAPTER U--AIR POLLUTION CONTROLS
PART 1065--ENGINE-TESTING PROCEDURES
Subpart A--APPLICABILITY AND GENERAL PROVISIONS
|
Submitting information to EPA under this part. |
|
|
Overview of this part 1065 and its relationship to the standard-setting part. |
|
|
Approval of alternate procedures. |
|
|
Overview of procedures for laboratory and field testing. |
|
|
Units of measure and overview of calculations. |
|
Subpart B--EQUIPMENT SPECIFICATIONS
|
Work inputs and outputs, accessory work, and operator demand. |
|
|
Fuel properties and fuel temperature and pressure. |
|
|
Engine cooling and lubrication. |
|
|
Exhaust gas recirculation. |
|
|
Dilution for gaseous and PM constituents. |
|
|
Gaseous and PM probes, transfer lines, and sampling system components. |
|
|
Batch sampling for gaseous and PM constituents. |
|
|
PM-stabilization and weighing environments for gravimetric analysis. |
|
|
PM-stabilization environment for in-situ analyzers. |
|
Subpart C--MEASUREMENT INSTRUMENTS
|
Overview and general provisions. |
|
|
Data updating, recording, and control. |
|
|
Performance specifications for measurement instruments. |
|
|
Work input and output sensors. |
|
|
Pressure transducers, temperature sensors, and dewpoint sensors. |
|
|
Dilution air and diluted exhaust flow meters. |
|
|
Sample flow meter for batch sampling. |
|
|
Nondispersive infra-red analyzer. |
|
|
Flame-ionization detector. |
|
|
Chemiluminescent detector. |
|
|
Nondispersive ultraviolet analyzer. |
|
|
Paramagnetic and magnetopneumatic Odetection analyzers. |
|
|
Zirconia (ZrO2) analyzer. |
|
|
PM inertial balance for field-testing analysis. |
|
Subpart D--CALIBRATIONS AND VERIFICATIONS
|
Overview and general provisions. |
|
|
Summary of required calibration and verifications. |
|
|
Verifications for accuracy, repeatability, and noise. |
|
|
Continuous gas analyzer system-response and updating-recording verification--general. |
|
|
Continuous gas analyzer system-response and updating-recording verification--with humidified-response verification. |
|
|
Pressure, temperature, and dewpoint calibration. |
|
|
Exhaust-flow calibration. |
|
|
Diluted exhaust flow (CVS) calibration. |
|
|
CVS and batch sampler verification (propane check). |
|
|
Sample dryer verification. |
|
|
Vacuum-side leak verification. |
|
|
H2O interference verification for CO2 NDIR analyzers. |
|
|
H2O and CO2 interference verification for CO NDIR analyzers. |
|
|
FID optimization and verification. |
|
|
Non-stoichiometric raw exhaust FID O2 interference verification. |
|
|
Nonmethane cutter penetration fractions. |
|
|
CLD CO2 and H2O quench verification. |
|
|
NDUV analyzer HC and H2O interference verification. |
|
|
NO2-to-NO converter conversion verification. |
|
|
PM balance verifications and weighing process verification. |
|
|
Inertial PM balance verifications. |
|
Subpart E--ENGINE SELECTION, PREPARATION, AND MAINTENANCE
|
Test engine preparation and maintenance. |
|
|
Maintenance limits for stabilized test engines. |
|
|
Durability demonstration. |
|
Subpart F--PERFORMING AN EMISSION TEST OVER SPECIFIED DUTY CYCLES
|
Cycle-validation criteria for operation over specified duty cycles. |
|
|
Pre-test verification procedures and pre-test data collection. |
|
|
Engine starting, restarting, shutdown, and optional repeating of void discrete modes. |
|
|
Validation of proportional flow control for batch sampling and minimum dilution ratio for PM batch sampling. |
|
|
Gas analyzer range validation, drift validation, and drift correction. |
|
|
PM sampling media (e.g., filters) preconditioning and tare weighing. |
|
|
PM sample post-conditioning and total weighing. |
|
Subpart G--CALCULATIONS AND DATA REQUIREMENTS
|
1980 international gravity formula. |
|
|
Flow meter calibration calculations. |
|
|
SSV, CFV, and PDP molar flow rate calculations. |
|
|
Amount of water in an ideal gas. |
|
|
Chemical balances of fuel, intake air, and exhaust. |
|
|
Removed water correction. |
|
|
THC and NMHC determination. |
|
|
THCE and NMHCE determination. |
|
|
Dilution air background emission correction. |
|
|
NOintake-air humidity and temperature corrections. |
|
|
CLD quench verification calculations. |
|
|
Buoyancy correction for PM sample media. |
|
Subpart H--ENGINE FLUIDS, TEST FUELS, ANALYTICAL GASES AND OTHER CALIBRATION STANDARDS
|
General requirements for test fuels. |
|
|
Residual and intermediate residual fuel. |
|
Subpart I--TESTING WITH OXYGENATED FUELS
|
Response factor determination. |
|
Subpart J--FIELD TESTING AND PORTABLE EMISSION MEASUREMENT SYSTEMS
|
PEMS auxiliary equipment for field testing. |
|
|
PEMS Calibrations and verifications. |
|
|
PEMS preparation for field testing. |
|
|
Engine starting, restarting, and shutdown. |
|
|
Emission test sequence for field testing. |
|
Subpart K--DEFINITIONS AND OTHER REFERENCE INFORMATION
|
Symbols, abbreviations, acronyms, and units of measure. |
|
February 27, 2007< !-- #EndDate -- >-->
|