Am I In Danger?
If electrical equipment is used in ways for which it is not designed, you can no longer depend on safety features
built in by the manufacturer. This may damage your equipment and cause employee injuries [for additional information, see
Power Tools].
Common Examples of Misused Equipment |
- Using multi-receptacle boxes designed to be mounted by fitting them with a power cord and placing them on
the floor.
- Fabricating extension cords with ROMEX® wire.
- Using equipment outdoors that is labeled for use only in dry, indoor locations.
- Attaching ungrounded, two-prong adapter plugs to three-prong cords and tools.
- Using circuit breakers or fuses with the wrong rating for over-current protection, e.g. using a 30-amp breaker in a
system with 15- or 20-amp receptacles. Protection is lost because it will not trip when the system's load has been
exceeded.
- Using modified cords or tools, e.g., removing ground prongs, face plates, insulation, etc.
- Using cords or tools with worn insulation or exposed wires.
|
How Do I Avoid Hazards?
- Use only equipment that is approved to meet OSHA
standards [29 CFR 1926.403(a)].
- Use all equipment according to the manufacturer's instructions [29 CFR 1926.403(b)(2)].
- Do not modify cords or use them incorrectly [for additional information, see
Flexible
Cords].
- Be sure equipment that has been shop fabricated or altered is in compliance.
|
This "handy box" is being improperly used as an extension cord receptacle. It is made
to be permanently mounted.
Equipment Not Used in Manner Prescribed |
Additional Information:
|