[Federal Register: January 13, 2003 (Volume 68, Number 8)]
[Rules and Regulations]               
[Page 1523-1525]
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
[DOCID:fr13ja03-6]                         


-----------------------------------------------------------------------


DEPARTMENT OF TRANSPORTATION


Federal Aviation Administration


14 CFR Part 39


[Docket No. 2001-NM-315-AD; Amendment 39-13011; AD 2002-26-22]
RIN 2120-AA64


 
Airworthiness Directives; Raytheon Model Hawker 800XP Airplanes


AGENCY: Federal Aviation Administration, DOT.


ACTION: Final rule.


-----------------------------------------------------------------------


SUMMARY: This amendment adopts a new airworthiness directive (AD), 
applicable to certain Raytheon Model Hawker 800XP airplanes, that 
requires installing jumper wires on the computer control switches to 
power the digital electronic engine control when overspeed protection 
is selected, and tying and stowing the jumper wires on the switches. 
The actions specified by this AD are intended to prevent loss of the 
overspeed protection function without the flightcrew's awareness, due 
to missing jumper wires, which could result in engine overspeed and 
possible uncommanded engine shutdown. This action is intended to 
address the identified unsafe condition.


DATES: Effective February 18, 2003.
    The incorporation by reference of certain publications listed in 
the regulations is approved by the Director of the Federal Register as 
of February 18, 2003.


ADDRESSES: The service information referenced in this AD may be 
obtained from Raytheon Aircraft Company, Department 62, PO Box 85, 
Wichita, Kansas 67201-0085. This information may be examined at the 
Federal Aviation Administration (FAA),


[[Page 1524]]


Transport Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., 
Renton, Washington; at the FAA, Wichita Aircraft Certification Office, 
1801 Airport Road, Room 100, Mid-Continent Airport, Wichita, Kansas; or 
at the Office of the Federal Register, 800 North Capitol Street, NW., 
suite 700, Washington, DC.


FOR FURTHER INFORMATION CONTACT: Jeff Pretz, Aerospace Engineer, 
Airframe and Propulsion Branch, ACE-118W, FAA, Wichita Aircraft 
Certification Office, 1801 Airport Road, Room 100, Mid-Continent 
Airport, Wichita, Kansas 67209; telephone (316) 946-4153; fax (316) 
946-4407.


SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal 
Aviation Regulations (14 CFR part 39) to include an airworthiness 
directive (AD) that is applicable to certain Raytheon Model Hawker 
800XP airplanes was published in the Federal Register on September 25, 
2002 (67 FR 60191). That action proposed to require installing jumper 
wires on the computer control switches to power the digital electronic 
engine control when overspeed protection is selected, and tying and 
stowing the jumper wires on the switches.


Comments


    Interested persons have been afforded an opportunity to participate 
in the making of this amendment. No comments were submitted in response 
to the proposal or the FAA's determination of the cost to the public.


Explanation of Editorial Change


    We have changed the service bulletin citation throughout this final 
rule to exclude the Service Bulletin/Kit Drawing Report Fax. (This form 
is intended to be completed by operators and submitted to the 
manufacturer to report compliance; however, this AD does not include 
such a requirement.)


Conclusion


    After careful review of the available data, the FAA has determined 
that air safety and the public interest require the adoption of the 
rule with the change previously described. The FAA has determined that 
this change will neither increase the economic burden on any operator 
nor increase the scope of the AD.


Cost Impact


    There are approximately 250 Model 800XP airplanes of the affected 
design in the worldwide fleet. The FAA estimates that 193 airplanes of 
U.S. registry will be affected by this AD. It will take approximately 5 
work hours per airplane for airplanes with two oxygen bottles, and 6 
work hours per airplane for airplanes with three oxygen bottles, to 
accomplish the required actions, at an average labor rate of $60 per 
work hour. The cost of required parts will be nominal. Based on these 
figures, the cost impact of the AD on U.S. operators is estimated to be 
$300 per airplane (for airplanes with two oxygen bottles) or $360 per 
airplane (for airplanes with three oxygen bottles).
    The cost impact figure discussed above is based on assumptions that 
no operator has yet accomplished any of the requirements of this AD 
action, and that no operator would accomplish those actions in the 
future if this AD were not adopted. The cost impact figures discussed 
in AD rulemaking actions represent only the time necessary to perform 
the specific actions actually required by the AD. These figures 
typically do not include incidental costs, such as the time required to 
gain access and close up, planning time, or time necessitated by other 
administrative actions.


Regulatory Impact


    The regulations adopted herein will not have a substantial direct 
effect on the States, on the relationship between the national 
Government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, it 
is determined that this final rule does not have federalism 
implications under Executive Order 13132.
    For the reasons discussed above, I certify that this action (1) is 
not a ``significant regulatory action'' under Executive Order 12866; 
(2) is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a 
significant economic impact, positive or negative, on a substantial 
number of small entities under the criteria of the Regulatory 
Flexibility Act. A final evaluation has been prepared for this action 
and it is contained in the Rules Docket. A copy of it may be obtained 
from the Rules Docket at the location provided under the caption 
ADDRESSES.


List of Subjects in 14 CFR Part 39


    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.


Adoption of the Amendment


    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration amends part 39 of 
the Federal Aviation Regulations (14 CFR part 39) as follows:


PART 39--AIRWORTHINESS DIRECTIVES


    1. The authority citation for part 39 continues to read as follows:


    Authority: 49 U.S.C. 106(g), 40113, 44701.




Sec.  39.13  [Amended]


    2. Section 39.13 is amended by adding the following new 
airworthiness directive:


2002-26-22 Raytheon Aircraft Company: Amendment 39-13011.
    Docket 2001-NM-315-AD.


    Applicability: Model Hawker 800XP airplanes, as listed in 
Raytheon Service Bulletin SB 76-3480, dated August 2001, excluding 
Service Bulletin/Kit Drawing Report Fax; certificated in any 
category.


    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must request approval for an 
alternative method of compliance in accordance with paragraph (b) of 
this AD. The request should include an assessment of the effect of 
the modification, alteration, or repair on the unsafe condition 
addressed by this AD; and, if the unsafe condition has not been 
eliminated, the request should include specific proposed actions to 
address it.


    Compliance: Required as indicated, unless accomplished 
previously.
    To prevent loss of the overspeed protection function without the 
flightcrew's awareness, due to missing jumper wires, which could 
result in engine overspeed and possible uncommanded engine shutdown, 
accomplish the following:


Jumper Wire Installation


    (a) Within 3 months or 300 flight hours after the effective date 
of this AD, whichever occurs first, do the actions specified in 
paragraphs (a)(1), (a)(2), and (a)(3) of this AD per Raytheon 
Service Bulletin SB 76-3480, dated August 2001, excluding Service 
Bulletin/Kit Drawing Report Fax.
    (1) Install a four-inch jumper wire between terminals 1 and 3 on 
the computer control switch ``NF.''
    (2) Install a six-inch jumper wire between terminals 1 and 3 on 
the computer control switch ``NG.''
    (3) Tie and stow the jumper wires on the computer control 
switches ``NF'' and ``NG'' using tie-wrap.


Alternative Methods of Compliance


    (b) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, Wichita Aircraft Certification 
Office (ACO), FAA. Operators shall submit their requests through an 
appropriate FAA Principal Maintenance


[[Page 1525]]


Inspector, who may add comments and then send it to the Manager, 
Wichita ACO.


    Note 2: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the Wichita ACO.


Special Flight Permits


    (c) Special flight permits may be issued in accordance with 
sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
CFR 21.197 and 21.199) to operate the airplane to a location where 
the requirements of this AD can be accomplished.


Incorporation by Reference


    (d) The actions shall be done in accordance with Raytheon 
Service Bulletin SB 76-3480, dated August 2001, excluding Service 
Bulletin/Kit Drawing Report Fax. This incorporation by reference was 
approved by the Director of the Federal Register in accordance with 
5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from 
Raytheon Aircraft Company, Department 62, PO Box 85, Wichita, Kansas 
67201-0085. Copies may be inspected at the FAA, Transport Airplane 
Directorate, 1601 Lind Avenue, SW., Renton, Washington; at the FAA, 
Wichita Aircraft Certification Office, 1801 Airport Road, Room 100, 
Mid-Continent Airport, Wichita, Kansas; or at the Office of the 
Federal Register, 800 North Capitol Street, NW., suite 700, 
Washington, DC.


Effective Date


    (e) This amendment becomes effective on February 18, 2003.




    Issued in Renton, Washington, on December 30, 2002.
Kevin Mullin,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 03-150 Filed 1-10-03; 8:45 am]

BILLING CODE 4910-13-P