Oxygen-Release Compound Remediation Tests
Type |
- Testing of Remediation Technologies
- Performance Monitoring
|
Location |
Laurel Bay, SC |
Partners |
U.S. Navy, Naval
Facilities Engineering Command (NAVFAC) |
Technology |
In-Situ Chemical Oxidation (Oxygen Addition to Ground
Water) |
Contaminants |
- Methyl tert-butyl ether (MTBE)
- Gasoline
|
Description |
USGS scientists have tested the effectiveness of injecting an oxygen-release
compound into the subsurface to remediate a plume of methyl
tert-butyl ether (MTBE) created by a leaking underground
storage tank at a gasoline station at Laurel Bay, SC. The scientists
had previously discovered that MTBE
naturally biodegrades when the MTBE plume encounters an interface
between anoxic (without oxygen) ground water and the oxic (with oxygen)
water in stream-bottom sediments. Because ground water is often
contaminated with MTBE in locations where such interfaces are not
present, the scientists hypothesized that it would be possible to
artificially create such an anoxic/oxic interface in anoxic, MTBE-contaminated
aquifers. A test was designed using an oxygen-release
compound to create an anoxic/oxic interface similar to those
found in streambed sediments and to intercept and remediate the
leading edge of the MTBE plume. The scientists used wells to inject
the oxygen-release compound into the anoxic plume and instrumented
the site with observation wells equipped with real-time oxygen probes.
Within 60 days following the introduction of oxygen, MTBE concentrations
decreased up to 87% from the originally high (> 20 milligrams per
liter) concentrations. This test showed that enhanced bioremediation
of MTBE-contaminated ground water could be a successful remediation
strategy.
Due to the success of the oxygen-release compound test on MTBE,
the U.S. Navy, the owner of the site, is interested in testing the
technology on some of the less soluble contaminants (toluene, ethylbenzene,
and xylene) still present in the source-area of the plume. Remediation
of benzene and MTBE contaminants to regulatory compliance levels
has been achieved at the Laurel Bay site by dissolution of the free
product in the subsurface site followed by natural attenuation processes.
However, remediation of less soluble toluene, ethylbenzene, and
xylene contaminants may require treatment (or removal) of the source
area. USGS scientists plan to treat the source area with an oxygen-release
compound to reduce the concentrations of contaminants there. Treatment
of the source area will most likely decrease the remediation time
associated with the less soluble compounds from the tens of years
required for the contaminants to leach out and attenuate to a few
years. The source area will be monitored to document the results.
|
More Information |
Note: Trade names are used for information purposes only and
do not denote endorsement by the U.S. Geological Survey. |
Contact |
James Landmeyer, USGS, South Carolina District, Columbia,
SC, |
Publications |
- Bradley, P.M., Chapelle, F.H. and Landmeyer, J.E., 2001,
- MTBE
mineralization in surface-water sediment microcosms under denitrifying
conditions: Applied and Environmental Microbiology, v. 67,
no. 4., p. 1975-1978.
- Bradley, P.M., Landmeyer, J.E., and Chapelle, F.H., 2001,
- Widespread
potential for microbial MTBE degradation in surface-water sediments:
Environmental Science and Technology, v. 35, no. 4, p. 658-662.
- Landmeyer, J.E., Chapelle, F.H., Herlong, H.H., and Bradley,
P.M., 2001,
- Methyl
tert-butyl ether biodegradation by indigenous aquifer microorganisms
under natural and artificial oxic conditions: Environmental
Science and Technology, v. 35, n. 6, p. 1118-1126.
|
Links |
Other Toxics Program In-Situ Chemical Oxidation Projects
Other USGS In-Situ Chemical Oxidation Projects
Toxics Program Information on Remediation of Fuel Oxygenates
USGS Information on Fuel Oxygenates
|
Back to Previous Page
Back to Toxics Program Remediation Activities Index
|
|