NTSB Training Center.

 


NTSB Training Center  •  45065 Riverside Parkway  •  Ashburn, Virginia 20147  •  571-223-3900

Driving Directions From Virginia - South via I-495

Map showing GWU-Ashburn campus.

Coming from the south (Virginia) on 495.  At Tysons Corner take Exit 12 - Dulles Toll Road/ Route 267 (a left lane exit). Pay toll (75 cents).

Continue approximately 11 miles and take Exit 9B, Route 28 North/Sully Road . (This is the last exit before the airport.)

Go through the toll booth (50 cents).

Proceed approximately 5 miles. Route 28 connects (and ends) at Route 7.

Follow signs to Leesburg - West (a left exit).

As you come off the ramp onto Route 7 stay in the right lane.

Go approximately ½ mile to the first traffic signal.

Turn right onto George Washington Blvd . (The corner will be marked by a low brick wall designating University Center.)

Continue along George Washington Blvd. for ½ mile and take a right on Riverside Parkway .

The NTSB Training Center is on the left side of the road. It is a large brick red complex of two attached buildings. The address is 45065 Riverside Parkway, Ashburn, Virginia.

Training Center street map.