[Code of Federal Regulations]
[Title 14, Volume 2]
[Revised as of January 1, 2008]
From the U.S. Government Printing Office via GPO Access
[CITE: 14CFR125.215]

[Page 1003]
 
                     TITLE 14--AERONAUTICS AND SPACE
 
CHAPTER I--FEDERAL AVIATION ADMINISTRATION, DEPARTMENT OF TRANSPORTATION 
                               (CONTINUED)
 
 PART 125_CERTIFICATION AND OPERATIONS: AIRPLANES HAVING A SEATING CAPACITY OF 
 
             Subpart F_Instrument and Equipment Requirements
 
Sec. 125.215  Operating information required.

    (a) The operator of an airplane must provide the following 
materials, in current and appropriate form, accessible to the pilot at 
the pilot station, and the pilot shall use them:
    (1) A cockpit checklist.
    (2) An emergency cockpit checklist containing the procedures 
required by paragraph (c) of this section, as appropriate.
    (3) Pertinent aeronautical charts.
    (4) For IFR operations, each pertinent navigational en route, 
terminal area, and approach and letdown chart;
    (5) One-engine-inoperative climb performance data and, if the 
airplane is approved for use in IFR or over-the-top operations, that 
data must be sufficient to enable the pilot to determine that the 
airplane is capable of carrying passengers over-the-top or in IFR 
conditions at a weight that will allow it to climb, with the critical 
engine inoperative, at least 50 feet a minute when operating at the 
MEA's of the route to be flown or 5,000 feet MSL, whichever is higher.
    (b) Each cockpit checklist required by paragraph (a)(1) of this 
section must contain the following procedures:
    (1) Before starting engines;
    (2) Before take-off;
    (3) Cruise;
    (4) Before landing;
    (5) After landing;
    (6) Stopping engines.
    (c) Each emergency cockpit checklist required by paragraph (a)(2) of 
this section must contain the following procedures, as appropriate:
    (1) Emergency operation of fuel, hydraulic, electrical, and 
mechanical systems.
    (2) Emergency operation of instruments and controls.
    (3) Engine inoperative procedures.
    (4) Any other emergency procedures necessary for safety.