Go to the USGS Home Page
Coastal and Marine Geology Program
Gulf of the Farallones Regional Bathymetry and Sidescan-Sonar Digital Mosaics

The image products shown below cover the Gulf of the Farallones region west of San Francisco and are the mosaics of digital bathymetric and sidescan-sonar data. The mosaics cover an area from 37 degrees 6 minutes to 37 degrees 48 minutes north latitude and 122 degrees 48 minutes to 123 degrees 36 minutes west longitude. The Farallon Islands are in the northeast portion of the mosaics and are part of the Gulf of the Farallones National Marine Sanctuary.

The availability and use of remotely sensed digital image data have increased rapidly over the last two decades. One application where remotely sensed image data are becoming a critical component is that of environmental analysis and monitoring. As an example, USGS partnered with the Gulf of the Farallones National Marine Sanctuary to use remotely sensed sidescan-sonar images to detect and map the location of 55-gallon drums that were dumped near and around the Farallon Islands from 1946 until 1970. Approximately 48,000 drums containing low-level radioactive waste were dumped in water depths ranging from about 100 to 2,500 meters covering an area of at least 1,400 sq. km (Karl et al., 1994). Because of the high number of drums littering the seafloor and the large disposal area involved, remotely sensed image data are one of the few promising tools for detecting and mapping barrel locations. One of the newer digital imaging systems is sidescan-sonar; it is an active system using acoustical waves to produce an image called a sonograph. The sonograph is a measure of backscatter reflectance properties of the seafloor and has many similarities to a side-looking airborne radar (SLAR) image. Digital sidescan-sonar images collected by a high-resolution (one- to two-meter pixels) system were used as input for barrel detection analysis (Chavez and Karl, 1995), as well as for mapping the regional backscatter characteristics of the area. The sidescan-sonar digital images were processed using the geometric and radiometric correction procedures, as well as the digital mosaicking package, developed by the USGS (Chavez, 1986). These data were used as input to spatial variability analysis, similar to those used on some lower resolution sidescan-sonar data (Chavez and Gardner, 1994).

The image products shown below were generated for our investigations using both bathymetry and sidescan-sonar image data:


  1. Bathymetry Digital Mosaic -

    [Bathymetry Mosaic][Shaded Relief Mosaic](Left: Bathymetry Mosaic, 230 kilobytes. Right: Shaded Relief Mosaic, 190 kilobytes.) This mosaic was generated using Seabeam bathymetric data collected by the National Oceanic and Atmospheric Administration (NOAA) with an original spatial resolution of 250 meters. The brightness values in the image represent depth -- darker implies shallower and brighter implies deeper. The depth ranges from about 50 meters on the shelf to greater than 3,000 meters off the shelf. The bathymetry image can be used to generate several different image products that are useful for structural enhancement and mapping. One of these products is a shaded relief image that is generated by 'placing' the sun at any angle and direction, then enhancing the topographic/structural information. Notice that the shaded relief image generated from the bathymetry data shows the regional structural patterns; the large seamounts just to the southwest of the image center and Pioneer Canyon in the lower portion of the image can be easily seen.




  2. Sidescan-Sonar Digital Mosaic (Non-Stereo, 250 kilobytes) -

    [Non-Stereo Side-Scan Sonar Mosaic] This digital image was generated by processing and mosaicking over a dozen individual sidescan-sonar strips. The data were processed for both geometric and radiometric distortions using the USGSMIPS software package (see MIPS Home Page). The data were collected by the SeaMarc 1A sidescan-sonar imaging system and cover an area approximately 50 km (31.4 mi) by 75 km (47.1 mi). The data were collected as part of a cooperative project between the U.S. Environmental Protection Agency and the USGS to obtain geologic information relevant to the process of designating a deep-ocean site for the disposal of dredge material from San Francisco Bay. The brightness is influenced by several different characteristics, including slope and surface roughness. The slopes facing the imaging system (center track lines) will be bright, while those facing away will be dark/in shadow. Surfaces that are relatively smooth (such as clay and silt) will be darker/have a lower backscatter return than those that are rough (such as gravel), which will be brighter/have a higher backscatter return.




  3. Sidescan-Sonar Digital Mosaic (Stereo, 290 kilobytes; Red and Blue/Green Glasses Required for 3-D Viewing) -

    [Stereoscopic Side-Scan Sonar Mosaic] The bathymetry and sidescan-sonar digital mosaics were geometrically registered/matched so that the same pixel in each image represents the same location on the seafloor. The geometric registration allows us to apply various enhancement and analysis techniques and procedures. One of the procedures used introduced parallax into the sidescan-sonar image in the horizontal direction as a function of the bathymetry data to generate a stereo pair. The topographic/3-D component can be viewed by using red and blue or red and green glasses (red on the left). Along with the shaded relief image this is an excellent way to study and analyze the topographic component of an area to detect and map the regional topographic structural patterns.




The main purpose of these digital mosaics is for geological and environmental analyses and mapping. The image products serve as good regional overviews and can be useful for applications other than the one intended by the U.S. Geological Survey. However, the geometric control available for the digital mosaicking was not of sufficient accuracy to make them useful for navigation; therefore, they should not be used for this purpose. For further information about these image products write or call either Pat S. Chavez, Jr. or Herman A. Karl.


Farallones Atlas More Information On the Western Region Coastal & Marine Geology Team Website:

Project Team:

Pat S. Chavez, Jr.Remote Sensing Scientist/ Team Leader
Herman A.KarlMarine Geologist
Miguel G. VelascoLead Image Processor on this project
JoAnn BowellImage Processor
Stuart C. SidesComputer Scientist
Rosendo R. GonzalezProgrammer
Deborah Lee SolteszWeb Page Design

References

Related Publications

Related Links



Return to Coastal and Marine Remote Sensing Research and Applications

For more information about this project, contact:

Pat S. Chavez Jr.

Email: pchavez@usgs.gov

U.S. Geological Survey
2255 N. Gemini Dr.
Flagstaff, AZ 86001

Tel: (520) 556-7221
FAX: (520) 556-7169

Herman A. Karl

Email: hkarl@octopus.wr.usgs.gov

U.S. Geological Survey
345 Middlefield Road, MS-999
U.S. Geological Survey
Menlo Park, California 94025

Tel: (415) 354-3084
FAX: (415) 329-3191


TerraWeb Home


Flagstaff Field Center


USGS Western Region
Coastal & Marine
Geology Team


USGS Home Page


U.S. Department of the Interior | U.S. Geological Survey | Jobs
Home | Search | Disclaimers & Privacy Web Rings
Send comments to webman@TerraWeb.wr.usgs.gov
URL:
Last Modified: Thu Oct 31 15:20:45 MST 2002
FirstGov: Your First Click to the U.S. Gov ernment