FSC 7530 JCP F30
25% GLAZED MANIFOLD
Manifold Paper February 1, 1999
--------------------------------------------------------------------------
Use information: This paragraph is informational only and is not
exclusively definitive of the end use.
For offset printing, generally face only, of multiforms and for
multiple copies of correspondence, requiring above average permanence.
Light weight, low bulk, and low opacity. Printed matter may include text
and light line illustrations.
Stock: Not less than 25 pct cotton or linen fibers. Groundwood pulp, not
to exceed 1 pct.
Note: \1\ Postconsumer recovered fiber, in any percentage, is
encouraged, provided that the requirements of this Standard are met.
Acidity: pH value shall average not less than 6.5.
Grammage (g/m \2\)................................ 30
Basis weight: 17 by 22 inches, 500 sheets
(pounds).......................................... 8
A tolerance of 5 pct shall be allowed.
Bursting strength: Average, not less than (kPa)... 60
Equivalent (lb/in \2\).......................... 10
Writing quality: Characters written with ball point and felt tip pens
shall be clear cut and free from excessive feathering.
General appearance: Paper shall conform to the standard sample(s)
adopted by the Government.
Color: The paper in the order (or publication) shall be uniform with a
target brightness of 80 pct. The color variation shall not exceed
DE(CIELAB)=1.0.
Finish and formation: Shall be uniform.
Cleanliness: The dirt count for each side of the paper shall not
exceed 250 specks per square meter. No sample sheet (600 to 650 cm\2\
in size) shall contain more than one defect with an equivalent area of
0.25 mm\2\ or greater.
Sampling and testing: Shall be conducted in accordance with standards in
Part 2, Government Paper Specification Standards.
------------------------------------------------------------------------
Unless otherwise specified, the following is automatically waived when
printing or duplicating is to be accomplished on commercial contract
Sizing: Paper shall be surface- and internal-sized suitable for
satisfactory printing on both sides of the paper on high-speed offset
presses equipped with continuous flow or brush dampening systems.
Color: Shall match the Government's standard sample for color. A
deviation of DE(CIELAB)=3.0 from the color standard is allowed.
Curl: Paper shall lie flat with either no tendency to curl or with a
curl which can be overcome under reasonable working conditions.
Size and trim: Sheets: Paper shall be furnished in the size(s) ordered
and shall be flat, trimmed square on four sides with clean smooth
edges, and evenly jogged. A tolerance of 2 mm (\1/16\
inch) shall be allowed except for sheets 216 by 356 mm (8\1/2\ by 14
inches) or less; then a tolerance of 1 mm (\1/32\ inch)
shall be allowed. Successive sheets within any package shall not
differ from each other by more than 0.5 mm (\1/64\ inch). Paper with
the long dimension 813 mm (32 inches) or less shall be considered
square if the variation does not exceed 1 mm (\1/32\ inch); over
813 mm (32 inches), 2 mm (\1/16\ inch).
Grain: Direction of the grain on flat paper shall be as ordered.
Pressroom conditions: The bulk of this paper will be used in air-
conditioned pressrooms maintained at 24 deg.C 2 deg.C
and 45 pct 8 pct relative humidity.
---------------------------------------------------------------------------
\1\ This grade is typically a low Government usage paper and
currently not readily and/or economically available with postconsumer
recovered fiber content. If a postconsumer fiber content is desired in
the paper, that number will be stated in the procurement document. Note,
recovered material (cotton/linen) is not a postconsumer recovered fiber.