![](https://webarchive.library.unt.edu/eot2008/20090509070322im_/http://www.osha.gov/SLTC/etools/hospital/images/bg_top.gif)
|
![](https://webarchive.library.unt.edu/eot2008/20090509070322im_/http://www.osha.gov/SLTC/etools/hospital/images/spacer.gif) |
Hospital eTool
Physical Therapy Module
Click on the area for more specific information.
|
Common safety and health topics:
Bloodborne pathogens are pathogenic microorganisms that are present in human blood and can cause disease in humans.
These pathogens include, but are not limited to, hepatitis B virus (HBV) and human immunodeficiency virus (HIV)
[1910.1030(b)].
|
Potential Hazard
-
Exposure to infectious diseases during physical therapy
treatment of patients through exposure to blood or other
potentially infectious body fluids (OPIM). OPIM
include human body fluids such as semen, vaginal secretions,
cerebrospinal fluid, synovial fluid, pleural fluid,
pericardial fluid, peritoneal fluid, amniotic fluid, saliva in
dental procedures, and any body fluid that is visibly
contaminated with blood.
Possible Solutions
|
|
-
Universal precautions shall be observed to prevent contact with blood or other potentially infectious
materials [1910.1030(d)(1)].
-
Under circumstances in which differentiation between body fluid types is difficult or impossible, all body fluids shall be considered
potentially infectious materials
[1910.1030(d)(1)].
|
|
-
The Physical Therapist shall wear
-
Personal Protective Equipment such as gloves when providing treatment for patients if exposure
to blood or OPIM is anticipated, (e.g., wounds or non-intact skin are present that might open up
during treatment)
[1910.1030(d)(3)(ix)].
-
Masks, Eye Protection, and Face Shields whenever splashes, spray, spatter, or droplets of blood or
other potentially infectious materials may be generated and eye, nose, or mouth contamination can be
reasonably anticipated [1910.1030(d)(3)(x)].
|
For additional information, see HealthCare Wide Hazards -
Bloodborne Pathogens and Universal Precautions.
|
|
Potential Hazard
Exposure of physical therapy staff to potential work related musculoskeletal
disorders (i.e., strain and sprain injuries to
back and shoulders areas) from constant lifting and reaching for
patients during treatment procedures and transfers.
Possible Solutions
|
Good work practice recommends employers address ergonomic
stressors in the physical therapy department and provide engineering controls and work
practice techniques to help minimize stressors such as:
|
|
-
Emphasize and teach the use of proper lifting techniques using good body mechanics.
-
Take time to stop and think (evaluate the lift).
-
Bend your knees, use arm and leg muscles, keep your back straight.
-
Use smooth and steady lifting motions.
-
Avoid lifting/reaching or working above shoulder height.
- Avoid awkward postures, such as twisting while lifting.
- Lift items close to the body.
- Avoid sitting or standing for long periods of time (take a break).
- Provide sufficient staff to handle lifts (i.e., get help).
|
|
-
Use mechanical aids to reduce the need to lift patients. Some examples include the use of:
-
Mechanical Lift Equipment
When lifting patients who cannot support their own weight into/out of whirlpools or tubs.
-
Sliding Boards
A slick board used under patients to help reduce friction during transfers (e.g., to and from
wheelchairs and treatment tables).
|
|
-
Use adjustable equipment such as tubs and therapy tables. Therapists can then adjust the equipment to fit
their individual height and comfort levels.
|
For additional information, see HealthCare Wide Hazards -
Ergonomics.
|
|
|
Potential Hazard
|
Physical Therapists use different modalities of treatment in caring for patients. Some
of these treatments involve:
- Ice, (e.g., ice machine and ice bags), or moist hot packs, (e.g., packs
stored in hot water in a machine called a hydroculator).
- Whirlpools.
- Workout equipment, (e.g., treadmills).
There is a potential slip and fall hazard if water is spilled on the floor or if electrical or other
cords run across pathways.
|
Possible Solutions
|
|
OSHA requires safe clean-up of spills and walkways free of obstructions:
-
Floors shall be kept clean and dry [1910.22(a)(2)].
|
|
- Non-slip mats and other dry standing places should be provided where practicable
[1910.22(a)(2)].
Use non-slip floor mats in whirlpool areas that tend to be slippery.
|
|
-
Aisles and passageways shall be kept
clear and in good repair, with no obstruction across
or in aisles that may create a hazard [1910.22(b)(1)].
Provide floor plugs for equipment, so power cords do
not run across pathways.
Good work practices include:
|
|
-
Placing a table to the side of the hydroculator (the machine that stores the moist heat
packs) and providing towels to rest the hot packs on to absorb the dripping water from the hot packs.
|
For additional information, see HealthCare Wide Hazards -
Slips/Falls.
|
|
|
Potential Hazard
Exposure to possible hazardous chemicals found and used in the PT area.
-
Cleaning chemicals such as glutaraldehyde used to disinfect whirlpools or tubs.
-
Gel used for ultrasound procedures.
-
Prescription medications, creams, or ointments rubbed into skin
of patient by therapist during physical therapy treatment.
Possible Solutions
-
Use less-toxic products if feasible and available, or use
other processes for sterilization. See the
National Anti-Microbial Network for lists of other approved cold
sterilization products.
-
Rooms in which glutaraldehyde is to be used should be well
ventilated and large enough to ensure adequate dilution of
vapor, with a minimum air exchange rate of 10 air changes per
hour.
-
Use increased dilution ventilation in whirlpool rooms
and x-ray rooms, along with the careful application of the glutaraldehyde with a long-handled brush rather than a
spray applicator.
-
Follow procedures for safe administration of medications and
creams. Therapists should wear gloves while applying certain
medications to patients (e.g., if skin contact with the
medication is indicated only for the patient).
-
Implement a written program that meets the requirements of
the
Hazard Communication Standard to provide for worker training,
warning labels, and access to Material Safety Data Sheets (MSDS)
for all hazardous chemicals/medications used by physical
therapists.
For additional information, see HealthCare Wide Hazards -
Hazardous Chemicals and
Glutaraldehyde.
|
|
Potential Hazard
Physical Therapists use different types of electrical treatment
equipment, such as the hydroculator and ultrasound devices, that
could be hazardous:
-
If water and electrical energies mix, it may result in a
possible shock hazard.
-
If equipment is used improperly,
excessive occupational exposure to ultrasound may occur.
Possible Solutions
|
A safety and health program that routinely monitors
the condition of equipment and addresses work practices of
therapists.
-
Visual inspection of cords; do not use if frayed or
damaged.
-
Employee visual inspection of equipment before using.
-
If something doesn't look right, don't use the machine; call for assistance.
-
Ensure that all electrical service near sources of
water is properly grounded [1910.304(f)(5)(v)].
|
Work Practices
|
|
-
Proper technique must be used when administering ultrasound and electrical stimulation treatments to avoid excessive exposure of
therapist's hand.
-
Improper technique could result in hand
weakness.
-
Physical therapist should use the handle rather
than the head of the ultrasound device when
administering treatments.
|
For additional information, see HealthCare Wide Hazards -
Electrical.
|
|
|
Potential Hazard
Exposure to Legionnaires' Disease by breathing
aerosolized water that contains the legionella bacteria. This
could occur in:
-
The shower or whirlpool area, or areas that have a spray
nozzle.
-
Cooling towers, evaporative condensers, fluid coolers, and
domestic hot-water systems.
These are water sources that may provide optimal
conditions for growth of the legionella bacteria.
Possible Solutions
For additional information, see HealthCare Wide Hazards -
Legionnaires' Disease.
-
Legionnaires'
Disease eTool. This eTool was designed to assist industrial hygienists
in the assessment of worksites for potential Legionnaires' disease. It
provides information on disease recognition, investigation procedures to
identify probable water sources, and control strategies.
|
|