Previous Years > 1977
December
- [12/14/1977] A knot in a wire rope is a recognized hazard for material handling.[1926.251(c)(3); 1915.112(b)(4); 1917.42(b)(5); 1918.62(b)(6)]
- [12/12/1977] Insulate or guard the employee from the energized part.[1926.950(c)(1)(i)]
- [11/30/1977] Elliott Company's plant-wide hard hat program.[1910.135]
- [11/23/1977] Supports required for safety nets.[1926.105]
- [11/16/1977] Positive identification of persons working underground in tunnels and shafts, caissons, cofferdams, compressed air tunnels.[1926.800(c); 1926.803]
- [10/12/1977] Carbon zinc batteries in blasting galvanometers.[1926.906(q); 1910.109(e)(4)(vii)]
- [10/11/1977] The point of operation guarding on the Biro Power Meat Cutters (bandsaws).[1910.212; 1910.213]
- [10/07/1977] Double-insulated tools and ground-fault protection on construction sites.[1926.400]
- [10/06/1977] Applicability of 29 CFR 1910.107 Spray Finishing Using Flammable and Combustible Materials as Referenced in 29 CFR 1910.94(c) Spray Finishing Operations.[1910.107; 1910.94(c)]
- [10/05/1977] Requirements for wire rope fittings (CASTLOK Bend-Master) in construction.[1926.251(c)]
- [08/26/1977] Construction of guardrails.[1926.451(d)(10)]
- [08/24/1977] Request for clarification on ground fault circuit interrupters on portable generators forwarded to the national office.[1926.400(b)]
- [08/22/1977] The wearing of hard hats.[1910.135; 1910.132; 1926.100]
- [08/17/1977] Allowable TLV of coke gases at the breathing levels of the employees.[1926.700; 1926.55(a); 1926.154]
- [07/26/1977] Presence sensing devices used to actuate mechanical power presses.[1910.217]
- [07/21/1977] OSHA's authority to take photographs during the course of an inspection.[1903.7]
- [07/19/1977] Fire wall requirements.[1910.106]
- [07/07/1977] Guardrails on outside crane platforms.[1926.550(a)(13)(ii)]
- [07/01/1977] Point of Operation Guarding, As Applied To The Dvorak Model 314 Iron Worker.[1910.212]
- [06/30/1977] Guarding requirements for radial saws.[1910.213(h)(1)]
- [06/29/1977] Wheel locks on rolling scaffold.[1926.451]
- [06/29/1977] The discharge from exits in the Blackwill Burner Company plant.[1910.36; 1910.36(c)(1); 1910.36(c)(2)]
- [06/24/1977] A safety sleeve designed for guarding projecting shaft ends and a clarification of the term "safety sleeve".[1910.219]
- [06/23/1977] Structural steel angles for cleats on fixed ladders.[1910.27]
- [06/14/1977] The issuance of a Program Directive to clarify the applicability fo OSHA standards.[1910.106]
- [06/14/1977] Testing of the WindGard.[1910.135]
- [06/14/1977] A request that the Automatic Nailing Machine be listed in 1910.217.[1910.217]
- [06/13/1977] Barricading Swing Radius of Backhoes.[1926.550; 1926.602]
- [05/20/1977] It is acceptable to use material other than fiber rope for boatswain's chairs.[1910.28(j)(2)]
- [05/19/1977] Clarification of a regulated area for battery type coke ovens[1910.1029(d)(2)(i)]
- [05/03/1977] Proof testing, as a unit, certain types of alloy steel chain lifting devices.[1910.184]
- [04/26/1977] Aerial lifts and digger derricks used by utility companies.[1926.550(a)(6); 1926.32(f)]
- [04/19/1977] Walking surface platforms attached to a billboard.[1910.21]
- [04/18/1977] A formal interpretation of 1910.107.[1910.107]
- [04/15/1977] Climbing structural members is a recognized hazard and prohibited.[1910.27]
- [04/07/1977] Misapplication of Rollover Protective Structures[1926.1000; 1926.1001; 1926.1002]
- [03/25/1977] The standard was not intended to apply to properly constructed and equipped solid fuel salamanders which are fueled by coke or coal and are used in structures under construction.[1926.154; 1926.700]
- [03/24/1977] "Massive release" is defined as gaseous vinyl chloride escaping under positive pressure; Clarification of the term "hazardous release";Clarification of protective clothing required to respond to a vi[1910.1017(b)(5); 1910.1017(i)(1); 1910.1017(h)]
- [03/21/1977] The point of operation hazard on power brakes.[1910.212]
- [03/08/1977] Wind Indicators and Rail Clamps.[1910.179]
- [03/02/1977] OSHA standards covering hydraulic accumulators.[1910.106]
- [03/01/1977] Installation of handrails on mobile belt loader conveyors.[1926.555(a)(8); 1910.261(a)(3)(v); 1910.265(c)(18)]
- [02/22/1977] Mechanical Power Presses.[1910.217]
- [02/21/1977] Newly Developed Hydrogen Storage Cylinders.[1910.101]
- [02/14/1977] Aisles and Passageways.[1910.22]
- [02/10/1977] Plugging into an unprotected outlet with a portable GFCI would be in violation of the standard.[1926.401]
- [02/03/1977] Interpretation on metal manhole ladder standards.[1910.268(h)(8)]
- [02/03/1977] Double insulated tools on construction sites.[1926.400]
- [01/26/1977] Guidance in relation to rules and regulations governing warehousing and transportation of powder-actuated tool cartridges.[1910.109]
- [01/21/1977] Additional Requirements for Safeguarding Typographical Errors.[1910.217]
- [01/19/1977] The storage of flammable and combustible liquids.[1910.106]
- [01/14/1977] The meaning of concurrent when related to two-hand controls on Mechanical Power Presses.[1910.211]
- [01/14/1977] Interpretation of Lockouts.[1910.261(b)(1)]
- [01/11/1977] The safety of telephone company personnel working under inclement weather conditions and also while exposed to induced currents and energized conductors.[1910.268; 1910.268(m)]
- [01/10/1977] The size of opening in the wire mesh mounted in the canopy structures of wheel and crawler tractors.[1926.604]
- [01/10/1977] Guarding of Punch Presses.[1910.217]
- [01/04/1977] Overhead and Gantry Cranes.[1910.179]