Fatality Assessment and Control Evaluation (FACE) Program |
|
Dump Truck Driver Dies After Unintentional Release of Asphalt |
| ||||||||||||||||||||
SummaryOn June 6, 2005 a 55-year-old male dump truck driver (Driver 1) died when he was buried waist deep in 400-degree Fahrenheit asphalt. Driver 1 stopped along the highway to help another dump truck driver (Driver 2), (both were independent truck drivers), who had experienced brake problems. As the two men were examining the pneumatic brake system at the rear of the disabled dump truck, the tailgate opened unexpectedly, spilling hot asphalt onto the decedent who was under the rear of the truck. To prevent similar incidents, the following recommendations have been made:
BackgroundOn June 6, 2005, the Kentucky Fatality Assessment and Control Evaluation program was informed of an occupational fatality via a television newscast. The local coroner’s office was contacted and on August 8, 2005, a site visit was made and interviews were conducted with the coroner, witness, and truck owner. Photographs were taken. According to witnesses, Driver 1 had owned and operated his own trucking business for over 30 years. He primarily hauled asphalt and gravel and recently retired. However, he had decided to leave retirement and contract with another independent owner/operator. Driver 2 was an independent dump truck driver who had been driving for approximately 20 years. He had purchased the 1984 used dump truck involved in this incident in 2004. After the purchase, Driver 2 had the truck bed redesigned so the tailgate section of the bed was flat instead of lipped. This design eliminated the lip so that tar, rock, etc. could not build up and hamper the closure of the tailgate. The lack of a lip eliminated the need to scrape asphalt or rock when closing and securing the tailgate. Instead of having a shovel on the truck, Driver 2 had a scraper (Photo 1). Driver 2 was a mechanic and performed the maintenance on his dump truck. The road construction company was working on a local highway construction project. At the time of the incident, the project was at the paving stage. Independent dump truck owner/operators from the area were contracted to haul asphalt to the construction site from the asphalt plant 20 miles away. According to an independent truck driver for the contractor, independent truckers had to meet strict criteria to haul asphalt for the contractor. Criteria included workers compensation insurance, a good driving record, a current commercial driver’s license, and compliance with Kentucky Department of Transportation regulations. The procedure for hauling asphalt was for dump truck drivers to drive into the asphalt facility, then a surfactant would be sprayed onto the bed of the truck. The truck would be weighed, loaded with asphalt, then weighed again. A ticket with the weight of the asphalt and time would be given to the driver and the asphalt load would be covered with a tarp. The driver would then drive the 400-degree Fahrenheit asphalt to the construction site, hand the ticket to a company employee and, upon instruction from the company employee, proceed to dump the asphalt load. This routine would be repeated all day until the contractor called an end to the day. Workers were paid by the load. According to a weather service, the temperature on June 6, 2005, ranged from 72°F – 90°F. Back to TopInvestigationOn June 6, 2005, two independent dump truck drivers were hauling asphalt for a construction company building a highway. The location of the highway was in the trucker’s home town. One independent trucker (Driver 2) was driving his own dump truck and the other (Driver 1) was driving another independent trucker’s dump truck. Driver 2 and Driver 1 had known each other for years and were friends. The two men drove their dump trucks to the asphalt plant 20 miles north of town. Driver 2 arrived first at the asphalt plant, ahead of Driver 1. Each driver drove into the facility, had the dump truck bed sprayed with surfactant and loaded with 400- degree Fahrenheit asphalt. Driver 2 preferred his truck bed to be loaded from the front to the back; however, the employees at the asphalt plant loaded the bed from the middle to the back. Therefore, asphalt was leaning against the tailgate of the dump truck. Driver 2 drove south out of the asphalt facility toward the highway construction site. Driver 1 was approximately 10 minutes behind him, and another dump truck driver employed by the contractor (Driver 3), was approximately 10 minutes behind Driver 1’s dump truck. It was approximately 7:00 AM and Driver 2 noticed the braking system on the dump truck was locking up. Driver 2 immediately began to look for a safe place to pull off the road and radioed the other dump truck drivers to inform them of his situation. Locating a flat spot on the shoulder on the opposite side of the highway, Driver 2 drove across the north bound lane and parked his dump trunk facing south on the northbound shoulder (Diagram 1 & Photo 2). Driver 1 heard the radio broadcast and when he saw Driver 2 on the north bound shoulder, he pulled over onto the south bound shoulder, parked, and crossed the highway to assist Driver 2. Approximately ten minutes later, Driver 3 pulled over to assist the other two drivers. Driver 2 raised the bed of the dump truck, exited the cab of his dump truck and began examining the airline connections located behind the cab on the driver’s side. One tank provided air for both the brakes and tailgate systems (Photo 7). As Driver 2 was examining the pneumatic connections, Driver 1 arrived and began to assist. Both drivers checked brakes and tailgate connections, and found all connections to be secure. They decided to examine the air line connections at the rear of the dump truck. With the front of the bed raised, there was less overhead room at the back of the truck. To make more room under the rear of the truck, Driver 2 lowered the bed of the dump truck to its flat position. This created more space at the back of the dump truck to observe where the air lines tied into the brakes and tailgate systems (Photo 3). Driver 2 crawled under the rear of the dump truck to examine the pneumatic connections from the underside. Driver 1 leaned down under the tailgate of the truck to examine the pneumatic connections from the top side. As the two men examined the connections, they heard air release from the cylinder for the tailgate. Driver 1, realizing the tailgate was going to open and asphalt would come out, tried to kick Driver 2 further under the truck to save him. According to an emergency report, approximately two tons of asphalt fell out from the tailgate, burying Driver 1 up to his waist in the hot asphalt. Driver 2 crawled out from under the truck and with his bare hands, tried to remove Driver 1 from the asphalt. Realizing rescuers needed more space and to try and stop more asphalt from falling on his friend, with both arms and hands severely burned, Driver 2 got back into the cab of the truck and moved it forward a few feet. By this time, Driver 3 had stopped and helped extract Driver 1 from the asphalt by using a shovel. At 7:10 AM a passing motorist called emergency services who arrived at 7:18 AM. Emergency rescuers used shovels to remove Driver 1 from the asphalt and performed CPR and took vital signs for about 20 minutes. The emergency report states Driver 1 was awake but confused and talking to his rescuers for 5 – 10 minutes before passing out. As emergency personnel were trying to save him, Driver 1 died at the scene. The local coroner was summoned. The coroner arrived and at 8:00 AM, declared Driver 1 dead at the scene. Driver 2 was taken to a hospital in another state and treated for severe burns on both arms and hands. Back to TopCause of DeathThe Certificate of Death states the cause of death was due to, “Thermal injuries of body due to heated asphalt. Traumatic asphyxia due to compression of body by heated asphalt. Industrial accident.” Recommendations and DiscussionRecommendation No. 1: Tailgate chains should always be secured to the dump truck.According to several dump truck drivers, chains on tailgates of dump trucks can be used to regulate the volume of rock when it is unloaded. The driver can choose to not hook the chains and dump the full load into one big pile, or hook the chains and spread the rock slowly in a line. When asphalt is unloaded, chains are not usually used. The tailgate is released, and the bed raised in increments to allow the asphalt to slide out of the truck bed. As a backup safety mechanism when hauling asphalt or any other material including rock, the chains should be secured tightly to the side of the truck. Chains should be secured before the bed is loaded with material and unsecured when the truck reaches its destination and is preparing to dump its load. Securing the chains would provide the driver a backup safety feature if the tailgate trip handle failed. Note: After this incident occurred, the company made the securing of tailgates with chains mandatory practice for all dump trucks. Now, when a dump truck is loaded, the tailgates are secured with chains to the sides of the dump truck before the driver is given the weight ticket and allowed to leave the facility. The chains are then released when the dump truck is ready to dump the load.
|
Photo 3: Picture
of brakes and pneumatic lines at rear of truck. Truck bed is flat. |
Photo 4: Picture
of bed raised at the approximate height when it was raised for Driver
1 and Driver 2 to examine pneumatic connections. |
Photo 5: Picture
of cylinder and pneumatic lines for tailgate trip handle system.
One line goes to air tank; the other to a switch in truck cab. |
Photo 7: Picture
of air tank shared by brake lines and tailgate system |
The Kentucky Fatality Assessment & Control Evaluation Program (FACE) is funded by a grant from the Centers for Disease Control and the National Institute of Safety and Health. The purpose of FACE is to aid in the research and prevention of occupational fatalities by evaluating events leading to, during, and after a work related fatality. Recommendations are made to help employers and employees to have a safer work environment.
To contact Kentucky State FACE program personnel regarding State-based FACE reports, please use information listed on the Contact Sheet on the NIOSH FACE web site Please contact In-house FACE program personnel regarding In-house FACE reports and to gain assistance when State-FACE program personnel cannot be reached.