(5) Mine map; escapeways; emergency evacuation; barricading. The
program of instruction for mine emergency evacuation and firefighting
approved by the District Manager under 30 CFR 75.1502 or the escape and
evacuation plan under 30 CFR 57.11053, as applicable, shall be used for
this course. The course shall include--
(i) A review of the mine map; the escapeway system; the escape,
firefighting, and emergency evacuation plans in effect at the mine; and
the location of abandoned areas; and
(ii) An introduction to the methods of barricading and the
locations of the barricading materials, where applicable.
(6) Roof or ground control and ventilation plans. The
course shall include an introduction to and instruction on the roof or ground
control plan in effect at the mine and procedures for roof and rib or ground
control; and an introduction to and instruction on the ventilation plan in
effect at the mine and the procedures for maintaining and controlling
(7) Health. The course shall include instruction on the
purpose of taking dust, noise, and other health measurements, and any health
control plan in effect at the mine shall be explained. The health provisions
of the act and warning labels shall also be explained.
(8) Cleanup; rock dusting. The course shall include
instruction on the purpose of rock dusting and the cleanup and rock dusting
program in effect at the mine, where applicable.
(9) Hazard recognition. The course shall include the
recognition and avoidance of hazards present in the mine, particularly any
hazards related to explosives where explosives are used or stored at the
(10) Electrical hazards. The course shall include
recognition and avoidance of electrical hazards.
(11) First aid. The course shall include instruction in
first aid methods acceptable to MSHA.
(12) Mine gases. The course shall include instruction in
the detection and avoidance of hazards associated with mine gases.
(13) Health and safety aspects of the tasks to which the new miner
will be assigned. The course shall include instruction in the health
and safety aspects of the tasks to be assigned, including the safe work
procedures of such tasks, the mandatory health and safety standards
pertinent to such tasks, information about the physical and health
hazards of chemicals in the miner's work area, the protective measures
a miner can take against these hazards, and the contents of the mine's
(14) Such other courses as may be required by the District
Manager based on circumstances and conditions at the mine.
(c) Methods, including oral, written, or practical demonstration, to
determine successful completion of the training shall be included in the
training plan. The methods for determining such completion shall be
administered to the miner before he is assigned work duties.
(d) A newly employed miner who has less than 12 months of mining
experience and has received the courses and hours of instruction in
paragraphs (a) and (b) of this section, within 36 months preceding
employment at a mine, does not have to repeat this training. Before the
miner starts work, the operator must provide the miner with the
experienced miner training in § 48.6(b) of this part and, if
applicable, the new task training in § 48.7 of this
part. The operator must also provide the miner with annual refresher training
and additional new task training, as applicable.
For more information : See MSHA's Program Policy Manual