{version = 1.05; (* of bndrec.p 2000 March 27}
(* begin module describe.bndrec *)
(*
name
bndrec: create marks file for a boundrectangle
synopsis
bndrec(bndrecp: in, bndmarks: out, output: out)
files
bndmarks: The marks for the lister program. Concatenate this
to the end of the marks.arrow file and put the result into the marks
file for lister.
bndrecp: parameters to control the program. The file must contain the
following parameters, one per line:
parameterversion: The version number of the program. This allows the
user to be warned if an old parameter file is used.
output: messages to the user
description
It is somewhat difficult to write the specific corners of boundrectangles
as defined in marks.arrow. This program takes a simple parameter file
and creates the user defined marks.
examples
The boundrectangle is called this way:
U 4000.0 -12.00 4019.0 -11.00 -217 boundrectangle
U says to lister to start working on a user defined mark
4000 is the left edge of the mark in bases
-12 is the lower edge of the mark in bits
4019 is the right edge of the mark in bases
-12 is the upper edge of the mark in bits
-217 is how far back the rectangle should be shifte in bases
The bndmarkp file creates this from:
documentation
see also
program that uses marks lister.p
definition of boundrectangles: marks.arrow this MUST be before
the bndmarks from this file.
author
Thomas Dana Schneider
bugs
technical notes
*)
(* end module describe.bndrec *)
{This manual page was created by makman 1.44}
{created by htmlink 1.52}