Driving Directions From Washington Dulles Airport – IAD (10 miles)

Exit airport and proceed north on Route 28 (Sully Road) towards Sterling.

Proceed approximately 6 miles. Route 28 connects (and ends) at Route 7.

Follow signs to Leesburg - West (a left exit).

As you come off the ramp onto Route 7 stay in the right lane.

Go approximately ½ mile to the first traffic signal.

Turn right onto George Washington Blvd . (The corner will be marked by a low brick wall designating University Center.)

Continue along George Washington Blvd. for ½ mile and take a right on Riverside Parkway .

The NTSB Training Center is on the left side of the road. It is a large brick red complex of two attached buildings. The address is 45065 Riverside Parkway, Ashburn, Virginia.