National Park Service LogoU.S. Department of the InteriorNational Park ServiceNational Park Service
National Park Service:  U.S. Department of the InteriorNational Park Service Arrowhead
Hot Springs National ParkThe front of the Fordyce Bathhouse, the park visitor center.
view map
text size:largestlargernormal
printer friendly
Hot Springs National Park
Prescribed Burn
aerial view of fire from almost directly overhead with wind blowing plume of smoke to the upper left of the photo
NPS photo
Aerial view of prescribe fire on North Mountain, April 12, 2006.

Hot Springs National Park is using prescribed or controlled fires to reduce the fuel load (leaf litter, limbs and logs) on the forest floor to prevent a hot, damaging fire.

Wildland Prescribed Fire Specialist from Buffalo National River and trained fire crew supervisor (Burn Boss) and crew members plan and carry out the burn.

These steps are followed when planning a prescribed burn:
1. Fire plan—outlines details according to regulations
2. Weather readings—wind and humidity must be within safe parameters
3. Equipment available—proper type and amount
4. Man power—enough to carry out a safe burn plan
5. Spread the word--press release
6. Ignite or light the fire at one edge of the area
7. Monitor burning area, making sure it doesn’t burn beyond the planned area
8. Cool off burn, let area burn out
9. Mop up

See pictures of the April 12, 2006 prescribed fire on North Mountain.

Close up of spring water dripping over algae covered rock formation.  

Did You Know?
The hot spring water at Hot Springs National Park becomes heated at a depth of approximately one mile before beginning the journey back to the surface through a fault.

Last Updated: November 16, 2007 at 17:17 EST