Tying Off and Safety Nets Training Guide (Taken from the "Tailgate Meetings that Work : A Guide to Effective Construction Safety Training" series)

• Does this topic relate to the work the crew is doing? If not, choose another topic.
  
• Did you read this Training Guide and fill in the blanks where the appears? (To find the information you need, look over the Safety Walkaround Checklist for this topic.)

Begin: How many times have you heard people make excuses for not tying off or using safety nets? Maybe you've heard comments like these:

• "Tying off is dangerous, because you can't move out from under an incoming load."

  or

• "Nets are too expensive, and they're dangerous to install."

Tying off and nets may have their problems, but think for a minute of the alternative -- a fall without protection. It's not a risk worth taking.

You or a crew member may want to add a personal story about tying off or safety nets.

ASK THE CREW THESE QUESTIONS:

After each question, give the crew time to suggest possible answers. Use the information following each question to add points that no one mentions.

1. When and where should you tie off?

• It depends on the kind of work being done and the kind of surface. Cal/OSHA says that if there are no guardrails, you should tie off:
  
  
  • When working on any structure at a height over 7½ feet, if you might fall:
    • from the perimeter
    • through elevator shafts, other shaftways, or openings
    • from steep sloped surfaces.
  • When working from thrustouts, trusses, beams, purlins, and plates at a height over 15 feet.
  • When working on skeleton steel of a multistory structure at a height over 15 feet.
  • When working on a steep roof (1/3 pitch or steeper) while using pneumatic tools.
  • When working from a boatswain chair, floating scaffold, needle-beam scaffold or suspended scaffold.

    On this job, you'll have to tie off --

Point out locations:_________________________________ _________________________________________________

2. If it's not possible to tie off, what should you do?

• If tying off isn't practical for some reason, we must use safety nets instead.

Point out locations:_________________________________ _________________________________________________

• Safety nets should be placed no more than 25 feet below the work area.
  
• Nets should extend at least 8 feet beyond the building or structure you're working on.
  
• No work can proceed unless the necessary fall protection is in place.

3. What if it's actually more dangerous to put up a net than to do the job without it?

• That can happen. If a job is short and installation of a net would be more hazardous than the work, you can go without the net. However, Cal/OSHA says you must work under immediate and competent supervision.

Supervision will be the responsibility of: ___________________

4. If you use fall protection equipment like a safety belt, harness, or lanyard, what do you need to check?

• Make sure you're using the right equipment for the job. For example, keep in mind that harnesses give better protection than safety belts.
  
• Be sure your equipment is safety-approved. Look for a label showing that it meets American National Standards Institute (ANSI) safety requirements.
  
• Use the equipment according to the manufacturer's instructions.
  
• Be sure everything is in good condition. Don't use the equipment if it isn't. For example, make sure that latches on belts are working properly, and that drop lines are not frayed or worn.
  
• Remove from service any safety belt, lanyard, or drop line that has been subjected to a load in actual use (in other words, if it has broken someone's fall).

5. Where should you place the anchor end of a lanyard?

• Anchor it at a level no lower than your waist. That way, you limit any fall to a maximum of four feet.
  
• Anchor it to a substantial structural member, or to a securely rigged catenary or pendant line.
  
• Don't anchor it to a pipe

. 6. What are some of the requirements for a drop line?

• A drop line (and its anchorage) must be able to support at least 5400 lbs.
  
• If a drop line is subject to fraying or rock damage, it must have a wire rope center

CAL/OSHA REGULATIONS

Explain: Most of the safety measures we've talked about are required by Cal/OSHA. We have to take these precautions—it's the law. I have a Checklist of the Cal/OSHA regulations on tying off and safety nets. If you'd like to know more, see me after the meeting.

COMPANY RULES

(Only if applicable.) Besides the Cal/OSHA regulations, we have some additional company rules about tying off and safety nets.

Discuss company rules: ______________________________ _________________________________________________

COMMENTS FROM THE CREW

Ask: Do you have any other concerns about tying off or safety nets? Do you see any problems on our job? (Let the steward answer first, if there is one.)

What about other jobs you've worked on? Have you had any experience with tying off or safety nets that might help us work safer on this job?

GENERAL SAFETY DISCUSSION

This is a time to discuss all safety concerns, not just today's topic. Keep your notes on this page before, during and after the safety meeting.

Are you aware of any hazards from other crews? Point out any hazards other crews are creating that this crew should know about. Tell the crew what you intend to do about those hazards.

Do we have any old business? Discuss past issues/problems. Report progress of investigations and action taken.

Any new business? Any accidents/near misses/complaints? Discuss accidents, near misses, and complaints that have happened since the last safety meting. Also recognize the safety contributions made by members of the crew.

Please remember, we want to hear from you about any health and safety issues that come up. If we don't know about problems, we can't take action to fix them.

To complete the training session:

• Circulate Sign-Off Form.
  
• Assign one or more crew member(s) to help with next safety meeting.
  
• Refer action items for follow-up. (Use the sample Hazard Report Form in the Reference Section of this binder, or your company’s own form.)

Sign Off Form
TYING OFF & SAFETY NETS

Tailgate Meetings That Work : Collection



Published in June, 1994 by: Labor Occupational Health Program, School of Public Health, 2515 Channing Way, University of California, Berkeley, CA 94720. Phone: (510) 642-5507.

Permission is granted to duplicate these materials for non-profit educational purposes, provided that copies are not offered for sale.

This paper appears in the eLCOSH website with the permission of the author and/or copyright holder and may not be reproduced without their consent. eLCOSH is an information clearinghouse. eLCOSH and its sponsors are not responsible for the accuracy of information provided on this web site, nor for its use or misuse.

eLCOSH | CDC | NIOSH | Site Map | Search | Links | Help | Contact Us | Privacy Policy