The Construction Safety Association of Ontario Hazard Summary A 43-year old, self-employed male sandblaster died of carbon monoxide poisoning at his outdoor work station. The victim was working alone and wearing personal protective equipment that included a NIOSH-approved Type CE sandblasting helmet. The helmet was supplied with breathing air by a manifold from a diesel-powered, oil-lubricated rotary screw compressor. This compressor also provided the sandblasting air. The equipment was old (circa 1970) and in very poor repair. Between the manifold and helmet were an in-line lubricator, a polycarbonate particulate filter, and a freestanding carbon filter. There was no aftercooler and no carbon monoxide removal or detection/alarm equipment in the system. Testing of the breathing air produced from this system showed that it contained in excess of 960 ppm of carbon monoxide. The CSA standard Z180.1-M85 "Compressed Breathing Air" recommends a maximum concentration of 5 PPM carbon monoxide. Also present were more than 3900 PPM of carbon dioxide, 55.5 PPM of methane, various hydrocarbons, and an unacceptable odor. The recommended maximum levels of carbon dioxide and methane are 500 PPM and 25 PPM, respectively. The oxygen content of the sample was deficient as well. Hazard Location There are two potential sources of carbon monoxide in breathing air from this type of system.
In this case, the compressor and air purification system used were not designed to produce breathing air meeting the quality specifications of the CSA standard. The equipment was so poorly maintained that both sources of carbon monoxide might have been involved. The hydrocarbon contaminants and low oxygen level in the breathing air sample indicate that overheating of the lubricant was the principal carbon monoxide source. Precautions
b) using a compressed breathing air cylinder source certified by the supplier as meeting the quality specifications of CSA Standard Z180.1-M85. Legal Requirements For further information or assistance, please contact your local office of the Ministry of Labor, the Industrial Accident Prevention Association, the Construction Safety Association of Ontario or other safe workplace association. Remember that while complying with occupational health and safety laws, you are also required to comply with applicable environmental laws. Queen's Printer for Ontario, 1999. Permission is granted to photocopy Ministry of Labor Alerts. Please distribute them widely and post them where people will see them.
|