OSHA Hazard Information Bulletins
Hydraulic Tractor/Semi-Trailer Dumper Platform.
 OSHA Safety and Health Information Bulletins - Table of Contents
- Information Date: 19860616
- Record Type: Hazard Information Bulletin
- Subject: Hydraulic Tractor/Semi-Trailer Dumper Platform.
June 16, 1986
MEMORANDUM FOR REGIONAL ADMINISTRATORS
| THRU: | JOHN B. MILES
Director
Directorate of Field Operations | |
| |
| FROM: | EDWARD J. BAIER
Director
Directorate of Technical Support | |
| |
| SUBJECT: | Safety Hazard Information Bulletin: Hydraulic Tractor/Semi-Trailer Dumper Platform | |
The Seattle Regional Office has brought to our attention a potentially
serious safety hazard related to the use of hydraulic tractor/semi-trailer
dumper platforms. To illustrate the type of equipment used, we are attaching
a copy of a photograph of a typical truck dumper system.
During a recent inspection conducted in Region X excessive wear in the
hydraulic ram universal joint and numerous cracks in the platform beams were
verified. Additionally, seven nonfatal collapses of this type of platform
have een documented. The problem has the potential of causing fatalities.
Generally, one to three workers are involved in activities related to this
operation unless the establishment adheres to a strict policy which prohibits
employee exposure.
The results of the field inspection conducted in Region X and the hazard
evaluation of the system are outlined in the following points:
(1) Jogging or shaking the platform when it is in the up position is
sometimes used to facilitate unloading. This practice induces stresses on
the dumper resulting in metal fatigue, cracks, and possible equipment
failure. Shaking the trailer to move the material being unloaded may produce
dangerous resonant frequencies that could further damage the components.
(2) The load limit of the platform should be observed. Some of the older
models of dumper platforms may not be designed to handle the new longer and
wider semi-trailers which may be loaded beyond the capacity of the dump
platform.
(3) When employees are exposed, flow restrictors should be installed in the
hydraulic cylinders at the hose entries. This is necessary to prevent rapid
fall of the platform in the event of hose break.
(4) Control stations should be installed at a sufficient distance from the
platform to prevent the operator's exposure to the trailer should it break
away and fall from the platform while the platform is in the up position.
(5) It is important to maintain good housekeeping around and under the
dumper. Excessive accumulation of debris can obstruct the freedom of
operation and maintenance of the dumper deck and other components.
(6) Excessive accumulation of debris on the deck can raise the trailer
enough to cause it to jump off the dumper backstop. Inspection procedures,
maintenance schedules, and safe work practices recommended by the
manufacturers should be followed to minimize accidents. Periodic inspection
by a registered engineer or manufacturer representative is advisable.
(7) A lockout procedure should be established to protect workers during
maintenance.
(8) Means, including audible and visual signals, should be used to assure
that employees are clear of the equipment during the dumping cycle.
(9) In the event that employees must work underneath the dumper when it is
in the up position, special procedures shall be taken to prevent the platform
from falling onto the employees.
We recommend that compliance and consultation personnel be aware of the
hazards addressed in this memorandum. Please disseminate this information to
Area Offices, State Plan States, and Consultation Projects.
OSHA Safety and Health Information Bulletins - Table of Contents |
|
Back to Top
www.osha.gov
