U.S. Department of the Interior |
Safety Alert No. 220 June 17, 2004 |
Contact:
Frank Pausina |
Lifting Fatality
Recently, drilling contractor personnel were engaged in the task of lifting bundles of 5-inch drill pipe by crane from the pipe rack to the adjacent catwalk for eventual placement on the rig floor. On the third or fourth lift, a bundle (9 joints) weighing approximately 5,760 lbs. began to swing horizontally. A drilling contractor employee, with only four days of experience offshore and in an attempt manually to stop the horizontal movement of the bundle, was pushed backward by the momentum of the bundle to a pipe rack post that prevented any farther backward movement of the employee. The bundle continued to swing and struck the employee in the chest while his back was positioned against the pipe rack post. The resulting injuries were fatal.
It was concluded, in part, in an MMS investigation of the incident that (1) the employee was not formally trained for the task, (2) his immediate supervisor was not aware of that lack of training, (3) the contractor had no policy against participation in rigging without formal rigger training, (4) the employee’s previous performance problems were not properly handled, (4) no Job Safety Analysis (JSA) was performed for the task, and (5) the designated operator had no procedure for selecting contractors, did not review the contractor’s safety policy, and had no clear safety directives for the company representatives on site. All of the above are considered, in varying degrees, causes of the accident.
It is therefore recommended to operators and contractors that:
For details of the accident, see OCS Report MMS 2004-046. Copies of the report may be obtained from the MMS Public Information Office located at 1201 Elmwood Park Boulevard, New Orleans, Louisiana 70123 (1-800-200-GULF or local 504-736-2519). The full report is also available on the MMS Gulf of Mexico OCS Region website.
MMSGOMR—
www.gomr.mms.gov