Fatality Assessment and Control Evaluation (FACE) Program |
|
A Spanish Speaking Roofer Dies After Falling From a Roof of a Residential Structure |
| |||||||||||
SummaryOn October 10, 2002, a 30-year-old Guatemalan male roofer was fatally injured when he fell from a residential structure roof. The roofing crew, including the victim, were installing a tarp from a ladder jack scaffold when the victim climbed onto the roof. The victim, who spoke Spanish, was reportedly told twice in Spanish by his foreman to get off the roof. The victim then fell approximately 30 feet to the ground below, landing on a cobblestone walkway. Emergency Medical Services (EMS) were notified and responded to the incident site within minutes. The victim was transported to a local hospital where he was pronounced dead. The Massachusetts FACE Program concluded that to prevent similar occurrences in the future, employers should:
IntroductionOn October 10, 2002, the Occupational Safety and Health Administration (OSHA) notified the Massachusetts FACE Program through the 24 hour Occupational Fatality Hotline, that on October 8, 2002, a 30-year-old male roofer was fatally injured when he fell from a residential building roof. An investigation was immediately initiated. On October 25, 2002, the Massachusetts FACE Program Director traveled to the roofing company's office where the victim’s supervisor and employer were interviewed. The death certificate, corporate information, OSHA fatality and catastrophe report and photographs of the residential structure were reviewed during the course of the investigation. The employer was a roofing contractor who had been in business approximately 30 years at the time of the incident. Company-wide, they employed approximately 27 individuals, of whom the majority were either carpenters or roofers. The company had five work crews. One of these crews was a "bilingual" crew, in which the supervisor spoke both fluent Spanish and English. Most of the crew members assigned to the bilingual crew, including the victim, spoke Spanish as their first language and spoke very little English. The victim, an emigrant from Guatemala, had been employed with the company for approximately two weeks at the time of the incident, but he had over two years of experience as a roofer with another company in Massachusetts. The company owner was the designated person in charge of safety. Prior to the incident, the company did not have a written safety program and did not provide employees safety training. Since the OSHA investigation, the company has developed a written safety program and sent employees to safety training classes. The company was a member of a national and a local roofing association. Employees had no union representation at the company. Back to TopInvestigationThe bilingual work crew to which the victim had been assigned consisted of four employees, one foreman, two roofers, including the victim, and one laborer. All work crews used a buddy system, where they paired up each new employee with a more experienced employee. All new employees were required to stay on the ground until their buddy thought that they were ready for roof work. The construction site was a residential house in a residential neighborhood. The house was an older structure that was approximately 30 feet high (two and a half stories). The company had been hired to replace a section of the house's roof. This roof section had a dormer window and a 10 pitch. The day of the incident was the crew's first day onsite. The crew arrived at the work site and set up extension ladders, ladder jacks and staging, and a tarp (Figure 1). The tarp was canvas and hung over the side of the house to limit the damage to the side of the house during the removal of the old asphalt roof shingles. While finishing installing the tarp, the employer stated that the victim climbed onto the roof. Both the company owner and the crew foreman reported that the victim was told two times in Spanish to get down from the roof. Once on the roof, it was reported that the victim started to walk along the roof towards a valley, the location where a dormer protrudes from the roof (Figure 2). When the victim was approximately two feet away from the valley, he lost his balance and fell approximately 30 feet to the walkway below. A call was placed by one of the work crew members, via cell phone, for emergency assistance, which responded to the incident site within minutes. The victim was transported to a local hospital by a neighboring town's emergency medical services ambulance, where he was pronounced dead. During the investigation, the company owner reported that harness and lanyards were available for employees at each project location. It was also reported that no fall protection was typically used while performing the tasks of setting up ladders, pump jacks, staging, tarps, and toe boards, and that fall protection is used for all succeeding tasks except for dismantling the equipment. After the incident, the employer had all employees go back to the office where they discussed the incident. During this discussion, the employer offered grief counseling, but none of the employees expressed interest. In addition, the employer gave all employees the following three days off work. Back to TopCause of DeathThe medical examiner listed the cause of death as blunt force head trauma. Back to TopRecommendations/DiscussionRecommendation # 1: Employers should develop, implement and enforce a comprehensive written safety and health program that includes, but is not limited to, a fall protection plan that addresses worker protection during scaffold erecting and dismantling.Discussion: In this case, the work location was a residential construction site and a ladder jack scaffold was going to be used to replace a section of the roof's shingles. The employer did not have a written safety and health program and the employer reported that employees did not use fall protection during ladder jack scaffold erection, tarp installation, and slide guard installation. Employers should develop, implement and enforce a written safety and health program that contains a fall protection plan. A summary of OSHA's draft proposed safety and health program rule, which discusses employee training, has been included at the end of this report. Employers should ensure that the company’s fall protection plan meets OSHA requirements for fall protection in residential and/or commercial construction. OSHA's fall protection standard requires employees engaged in residential construction activity six feet or more above a lower level be protected by fall protection (1926 Subpart M). When working from scaffolding, OSHA's scaffold standard (1926 Subpart L) states workers on ladder jack scaffolds are to be protected by a personal fall arrest system at heights over 10 feet. OSHA also requires that when erecting and dismantling scaffolding, including ladder jack scaffolding, fall protection should be provided to employees, unless the employer can successfully show, through a competent person, that a greater hazard exists as a result of using the fall protection. In the rare cases where OSHA might agree that greater hazards exists when using fall protection during erecting scaffolding, employers should ensure that employees are protected from falling once the scaffold setup is complete and prior to starting other tasks. In addition, the installation and removal of tarps or other sheeting materials is not considered part of the erection or dismantling of scaffolding; therefore, fall protection must be used during this task.
|
Figure 1 -
Incident Location |
Figure
2 - Victim's location prior to the fall |
Summary Of OSHA'S Draft Proposed Safety and Health Program
Rule For Employers
(29 CFR 1900.1 Docket No. S&H-0027)*
Core elements
Basic obligations
Set up a safety and health program, with employee input, to manage workplace safety and health to reduce injuries, illnesses and fatalities.
Ensure that the safety and health program is appropriate to workplace conditions taking into account factors such as hazards employees are exposed to and number of employees.
Establish and assign safety and health responsibilities to an employee. The assigned person must have access to relevant information and training to carryout their safety and health responsibilities and receive safety and health concerns, questions and ideas from other employees.
Employee participation
Regularly communicate with employees about workplace safety and health matters and involve employees in hazard identification, assessment, prioritization, training, and program evaluation.
Establish a way and encourage employees to report job-related fatalities, injuries, illnesses, incidents, and hazards promptly and to make recommendations about appropriate ways to control those hazards.
Identify and assess hazards to which employees
are exposed
Conduct inspections of the workplace at least every two years and when safety and health information change or when a change in workplace conditions indicates that a new or increased hazard may be present.
Evaluate new equipment, materials, and processes for hazards before introducing them into the workplace and assess the severity of identified hazards and rank those hazards that cannot be corrected immediately according to their severity.
Investigate safety and health events in
the workplace
Thoroughly investigate each work-related death, serious injury, illness,
or incident (near miss).
Safety and health program record keeping
Keep records of identified hazards, their assessment and actions taken or the plan to control these hazards.
Hazard prevention and control
Comply with the hazard prevention and control requirements of the OSHA standards by developing a plan for coming into compliance as promptly as possible, which includes setting priorities and deadlines for controlling hazards and tracking the progress.
Information and training
Ensure each employee is provided with safety and health information and training.
If an employee is exposed to hazards, training must be provided on the nature of the hazards to which they are exposed to and how to recognize these hazards. Training must include what is being done to control these hazards and protective measures employees must follow to prevent or minimize their exposures.
Safety and health training must be provided to current and new employees and before assigning a job involving exposure to a hazard. The training should be provided routinely, when safety and health information is modified or a change in workplace conditions indicates a new or increased hazard exists.
Program evaluation and maintenance
Evaluate the safety and health program at least once every two years or as often as necessary to ensure program effectiveness.
Revise the safety and health program in a timely manner once deficiencies have been identified.
Multi-employer workplaces
The host employer's responsibility is to provide information about hazards and their controls, safety and health rules, and emergency procedures to all employers at the workplace. In addition, the host employer must ensure that assigned safety and health responsibilities are appropriate to other employers at the workplace.
The contract employer responsibility is to ensure that the host employer is aware of hazards associated with the contract employer's work and how the contract employer is addressing them. In addition, the contract employer must advise the host employer of any previously unidentified hazards at the workplace.
* Date issued November 23, 1998. Full text available on www.osha.gov/SLTC/safetyhealth/nshp.html (Link updated 11/13/2006)
To contact Massachusetts State FACE program personnel regarding State-based FACE reports, please use information listed on the Contact Sheet on the NIOSH FACE web site Please contact In-house FACE program personnel regarding In-house FACE reports and to gain assistance when State-FACE program personnel cannot be reached.