[Code of Federal Regulations] [Title 40, Volume 17] [Revised as of July 1, 2004] From the U.S. Government Printing Office via GPO Access [CITE: 40CFR86.336-79] [Page 609] TITLE 40--PROTECTION OF ENVIRONMENT CHAPTER I--ENVIRONMENTAL PROTECTION AGENCY (CONTINUED) PART 86_CONTROL OF EMISSIONS FROM NEW AND IN-USE HIGHWAY VEHICLES AND ENGINES--Table of Contents Subpart D_Emission Regulations for New Gasoline-Fueled and Diesel-Fueled Heavy-Duty Engines; Gaseous Exhaust Test Procedures Sec. 86.336-79 Diesel engine test cycle. (a) The following 13-mode cycle shall be followed in dynamometer operation tests of heavy-duty Diesel engines. Gasoline-fueled engines are covered in Sec. 86.335. -------------------------------------------------------------------------------------------------------------------------------------------------------- Observed Time in mode (minutes) torque -------------------------- Maximum Test Segment Mode No. Engine Speed (percent of cumulative maximum Minimum Maximum time observed) (minutes) -------------------------------------------------------------------------------------------------------------------------------------------------------- 1........................................ 1........................... Curb-idle.................. ........... 4.5 6.0 ........... 1........................................ 2........................... Intermediate............... 2 4.5 6.0 ........... 1........................................ 3........................... ......do................... 25 4.5 6.0 ........... 1........................................ 4........................... ......do................... 50 4.5 6.0 42 1........................................ 5........................... ......do................... 75 4.5 6.0 ........... 1........................................ 6........................... ......do................... 100 4.5 6.0 ........... 1........................................ 7........................... Curb-idle.................. ........... 4.5 6.0 ........... 2........................................ 8........................... Rated...................... 100 4.5 6.0 ........... 2........................................ 9........................... ......do................... 75 4.5 6.0 ........... 2........................................ 10.......................... ......do................... 50 4.5 6.0 36 2........................................ 11.......................... ......do................... 25 4.5 6.0 ........... 2........................................ 12.......................... ......do................... 2 4.5 6.0 ........... 2........................................ 13.......................... Curb-idle.................. ........... 4.5 6.0 ........... -------------------------------------------------------------------------------------------------------------------------------------------------------- (b) During each mode the specified speed shall be held to within 50 rpm. Torque for each mode must be held at the specified value 2 percent of the maximum torque observed. For example, mode 4 torque shall be held between 48 and 52 percent of maximum torque (50 2%). (c) If the operating conditions specified in paragraph (b) of this section for modes 3, 4, 5, 9, 10, and 11 cannot be maintained, the Administrator may authorize deviations from the specified load conditions. Such deviations shall not exceed 10 percent of the maximum torque at the test speed. The minimum deviations, above and below the specified load, necessary for stable operation shall be determined by the manufacturer and approved by the Administrator prior to the test run. Emission tests shall be performed at each of the approved load settings, one above and one below the operating conditions specified in paragraph (a) of this section. The emission values obtained shall be calculated in accordance with Sec. 86.345 except that the weighting factor shall be 0.04. (d) If the Administrator determines that an engine shall be tested as an automatic transmission code engine, then a load shall be applied by the dynamometer during the idle modes (1, 7, and 13) such that the engine speed is decreased from the recommended dynamometer-idle speed to the recommended curb-idle speed. The engine-idle torque recorded for the calculations in Sec. 86.345 shall be zero.