[Code of Federal Regulations] [Title 40, Volume 27] [Revised as ofJuly 1, 2003] From the U.S. Government Printing Office via GPO Access [CITE: 40CFR428.116] [Page 84] TITLE 40--PROTECTION OF ENVIRONMENT CHAPTER I--ENVIRONMENTAL PROTECTION AGENCY (CONTINUED) PART 428--RUBBER MANUFACTURING POINT SOURCE CATEGORY--Table of Contents Subpart K--Latex Foam Subcategory Sec. 428.116 Pretreatment standards for new sources. Any new source subject to this subpart that introduces process wastewater pollutants into a publicly owned treatment works must comply with 40 CFR part 403. In addition, the following pretreatment standard establishes the quantity or quality of pollutants or pollutant properties, controlled by this section, which may be discharged to a publicly owned treatment works by a new point source subject to the provisions of this subpart: ------------------------------------------------------------------------ Pretreatment standards ----------------------------- Average of daily Pollutant or pollutant property Maximum values for 30 for any 1 consecutive days day shall not exceed- - ------------------------------------------------------------------------ Metric units (kg/kkg of raw material) ------------- Zinc...................................... 0.058 0.024 BOD5...................................... (\1\) (\1\) TSS....................................... (\1\) (\1\) pH........................................ (\1\) (\1\) ------------- English units (lb/1,000 lb of raw material) ------------- Zinc...................................... 0.058 0.024 BOD5...................................... (\1\) (\1\) TSS....................................... (\1\) (\1\) pH........................................ (\1\) (\1\) ------------------------------------------------------------------------ \1\ No limitation. [40 FR 2345, Jan. 10, 1975, as amended at 60 FR 33964, June 29, 1995]