[Code of Federal Regulations] [Title 40, Volume 27] [Revised as ofJuly 1, 2003] From the U.S. Government Printing Office via GPO Access [CITE: 40CFR426.105] [Page 40] TITLE 40--PROTECTION OF ENVIRONMENT CHAPTER I--ENVIRONMENTAL PROTECTION AGENCY (CONTINUED) PART 426--GLASS MANUFACTURING POINT SOURCE CATEGORY--Table of Contents Subpart J--Glass Tubing (Danner) Manufacturing Subcategory Sec. 426.105 Standards of performance for new sources. The following standards of performance establish the quantity or quality of pollutants or pollutant properties, controlled by this section, which may be discharged by a new source subject to the provisions of this subpart: ------------------------------------------------------------------------ Effluent limitations ----------------------------- Average of daily Effluent characteristic Maximum values for 30 for any 1 consecutive days day shall not exceed- - ------------------------------------------------------------------------ Metric units (g/kkg of furnace pull) ------------- TSS....................................... 0.4 0.2 pH........................................ (\1\) (\1\) ------------- English units (lb/1,000 lb of furnace pull) ------------- TSS....................................... 0.0004 0.0002 pH........................................ (\1\) (\1\) ------------------------------------------------------------------------ \1\ Within the range 6.0 to 9.0.