Printable Version

Office Energy Checklist

The following is a simple checklist of energy conservation/efficiency measures to use at the office. This document is also available as a printable flyer for download (PDF 86 KB). Download Adobe Reader.

	Replace incandescent lights with compact fluorescent lights (CFLs) for desk lamps and overhead lighting. Using CFLs instead of comparable incandescent bulbs can save about 50 percent on your lighting costs. CFLs use only one-fourth the energy and last up to 10 times longer.
	Switch off all unnecessary lights. Use dimmers, motion sensors, or occupancy sensors to automatically turn off lighting when not in use to reduce energy use and costs.
	Turn off lights when you leave at night.
	Use natural lighting or daylighting. When feasible, turn off lights near windows
	Use task lighting; instead of brightly lighting an entire room, focus the light where you need it, to directly illuminate work areas.
	Use energy efficient ENERGY STAR® products.
	Close or adjust window blinds to block direct sunlight to reduce cooling needs during warm months. Overhangs or exterior window covers are most effective to block sunlight on south-facing windows.
	In the winter months, open blinds on south-facing windows during the day to allow sunlight to naturally heat your workspace. At night, close the blinds to reduce heat loss at night.
	Unplug equipment that drains energy when not in use (i.e. cell phone chargers, fans, coffeemakers, desktop printers, radios, etc.).
	Turn off your computer and monitors at the end of the work day, if possible. If you leave your desk for an extended time, turn off your monitor. (See Office Equipment.)
	Turn off photocopier at night or purchase a new copier with low standby feature. Purchase printers and fax machines with power management feature and use it.
	Coordinate with vending machine vendor to turn off advertising lights.
	Have a qualified professional perform an energy audit. Check with your utility company for names of auditors.
	Clean or change furnace filters once a month during the heating season.
	Check furnace ducts for disconnects or leaks.
	Ensure HVAC ductwork is well insulated.
	Ensure adjustable speed drives are operating properly.
	Insulate water heater, hot water piping and tanks to reduce heat loss.
	Install low-flow toilets and shower heads.
	Verify the energy management system (EMS) switches into setback mode during unoccupied hours. Also, time clocks and computer controls may need adjustments after power outages or seasonal time changes.
	Install meters to track energy use.
	Visit Businesses Can Save Energy this Winter with Help from EPA and ENERGY STAR for 5 steps to save energy this winter. The steps are based on lessons learned from ENERGY STAR business and organization partners.
	Save paper. Photocopy only what you need. Always use the second side of paper, either by printing on both sides or using the blank side as scrap paper.
	Collect your utility bills. Separate electricity and fuel bills. Target the largest energy consumer or the largest bill for energy conservation measures.
	Carpool, bike, or use mass transit when commuting to work.
	To save gas: drive the speed limit, accelerate and decelerate slower, and make sure tires are pumped up.
	Use coffee mugs instead of disposable cups.