[Federal Register: January 18, 2007 (Volume 72, Number 11)]
[Rules and Regulations]
[Page 2177-2179]
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
[DOCID:fr18ja07-5]
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. FAA-2007-26855; Directorate Identifier 2006-NM-264-AD;
Amendment 39-14888; AD 2007-02-01]
RIN 2120-AA64
Airworthiness Directives; Dassault Model F2000EX Airplanes
AGENCY: Federal Aviation Administration (FAA), Department of
Transportation (DOT).
ACTION: Final rule; request for comments.
-----------------------------------------------------------------------
SUMMARY: We are adopting a new airworthiness directive (AD) for the
products listed above. This AD results from mandatory continuing
airworthiness information (MCAI) issued by an aviation authority of
another country to identify and correct an unsafe condition on an
aviation product. The MCAI describes the unsafe condition as incorrect
monitoring of the fire detection system; therefore, its integrity is
not guaranteed at all times. This AD requires actions that are intended
to address the unsafe condition described in the MCAI.
DATES: This AD becomes effective February 2, 2007.
The Director of the Federal Register approved the incorporation by
reference of a certain document listed in this AD as of February 2,
2007.
We must receive comments on this AD by March 19, 2007.
ADDRESSES: You may send comments by any of the following methods:
DOT Docket Web Site: Go to http://dms.dot.gov and follow
the instructions for sending your comments electronically.
Fax: (202) 493-2251.
Mail: Docket Management Facility, U.S. Department of
Transportation, 400 Seventh Street, SW., Nassif Building, Room PL-401,
Washington, DC 20590-0001.
Hand Delivery: Room PL-401 on the plaza level of the
Nassif Building, 400 Seventh Street, SW., Washington, DC, between 9
a.m. and 5 p.m., Monday through Friday, except Federal holidays.
Federal Rulemaking Portal: http://www.regulations.gov.
Follow the instructions for submitting comments.
Examining the AD Docket
You may examine the AD docket on the Internet at http://dms.dot.gov
; or in person at the Docket Management Facility between 9
a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD
docket contains this AD, the regulatory evaluation, any comments
received, and other information. The street address for the Docket
Office (telephone (800) 647-5227) is in the ADDRESSES section. Comments
will be available in the AD docket shortly after receipt.
FOR FURTHER INFORMATION CONTACT: Tom Rodriguez, Aerospace Engineer,
International Branch, ANM-116, FAA, Transport Airplane Directorate,
1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425)
227-1137; fax (425) 227-1149.
SUPPLEMENTARY INFORMATION:
[[Page 2178]]
Streamlined Issuance of AD
The FAA is implementing a new process for streamlining the issuance
of ADs related to MCAI. This streamlined process will allow us to adopt
MCAI safety requirements in a more efficient manner and will reduce
safety risks to the public. This process continues to follow all FAA AD
issuance processes to meet legal, economic, Administrative Procedure
Act, and Federal Register requirements. We also continue to meet our
technical decision-making responsibilities to identify and correct
unsafe conditions on U.S.-certificated products.
This AD references the MCAI and related service information that we
considered in forming the engineering basis to correct the unsafe
condition. The AD contains text copied from the MCAI and for this
reason might not follow our plain language principles.
Discussion
The European Aviation Safety Agency (EASA), which is the Technical
Agent for the member states of the European Community, has issued
Emergency Airworthiness Directive 2006-0356-E, dated November 30, 2006
(referred to after this as ``the MCAI''), to correct an unsafe
condition for the specified products. The MCAI states that
troubleshooting of a ``ENG 1 FIRE DETECT FAIL'' CAS (crew alerting
system) message that occurred on an in-service aircraft revealed that
the detector threshold tolerances could not identify a single failure
of one engine fire detector loop out of the two present on each engine.
The fire detection system is therefore not correctly monitored, and its
integrity is not guaranteed at all times. The goal of the MCAI is to
verify the fire detection system integrity by mandating a one-time
inspection and, in case of findings, to replace the faulty detector
pending further modification of the monitoring system. The MCAI will be
revised/superseded once the terminating corrective action for the
monitoring function has been approved. You may obtain further
information by examining the MCAI in the AD docket.
Relevant Service Information
Dassault has issued Service Bulletin F2000EX-137, Revision 1, dated
December 7, 2006. The actions described in this service information are
intended to correct the unsafe condition identified in the MCAI.
FAA's Determination and Requirements of This AD
This product has been approved by the aviation authority of another
country, and is approved for operation in the United States. Pursuant
to our bilateral agreement with this State of Design Authority, they
have notified us of the unsafe condition described in the MCAI and
service information referenced above. We are issuing this AD because we
evaluated all the information provided by the State of Design Authority
and determined the unsafe condition exists and is likely to exist or
develop on other products of the same type design.
Differences Between the AD and the MCAI or Service Information
We have reviewed the MCAI and related service information and, in
general, agree with their substance. But we might have found it
necessary to use different words from those in the MCAI to ensure the
AD is clear for U.S. operators and is enforceable. In making these
changes, we do not intend to differ substantively from the information
provided in the MCAI and related service information.
We might also have required different actions in this AD from those
in the MCAI in order to follow FAA policies. Any such differences are
described in a separate paragraph of the AD. These requirements take
precedence over the actions copied from the MCAI.
FAA's Determination of the Effective Date
An unsafe condition exists that requires the immediate adoption of
this AD. The FAA has found that the risk to the flying public justifies
waiving notice and comment prior to adoption of this rule because
incorrect fire detector threshold tolerance could lead to undetected
failure of the fire detectors. Therefore, we determined that notice and
opportunity for public comment before issuing this AD are impracticable
and that good cause exists for making this amendment effective in fewer
than 30 days.
Comments Invited
This AD is a final rule that involves requirements affecting flight
safety, and we did not precede it by notice and opportunity for public
comment. We invite you to send any written relevant data, views, or
arguments about this AD. Send your comments to an address listed under
the ADDRESSES section. Include ``Docket No. FAA-2007-26855; Directorate
Identifier 2006-NM-264-AD'' at the beginning of your comments. We
specifically invite comments on the overall regulatory, economic,
environmental, and energy aspects of this AD. We will consider all
comments received by the closing date and may amend this AD because of
those comments.
We will post all comments we receive, without change, to http://dms.dot.gov
, including any personal information you provide. We will
also post a report summarizing each substantive verbal contact we
receive about this AD.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to
issue rules on aviation safety. Subtitle I, section 106, describes the
authority of the FAA Administrator. ``Subtitle VII: Aviation
Programs,'' describes in more detail the scope of the Agency's
authority.
We are issuing this rulemaking under the authority described in
``Subtitle VII, Part A, Subpart III, Section 44701: General
requirements.'' Under that section, Congress charges the FAA with
promoting safe flight of civil aircraft in air commerce by prescribing
regulations for practices, methods, and procedures the Administrator
finds necessary for safety in air commerce. This regulation is within
the scope of that authority because it addresses an unsafe condition
that is likely to exist or develop on products identified in this
rulemaking action.
Regulatory Findings
We determined that this AD would not have federalism implications
under Executive Order 13132. This AD would not have a substantial
direct effect on the States, on the relationship between the national
Government and the States, or on the distribution of power and
responsibilities among the various levels of government.
For the reasons discussed above, I certify this regulation:
1. Is not a ``significant regulatory action'' under Executive Order
12866;
2. Is not a ``significant rule'' under the DOT Regulatory Policies
and Procedures (44 FR 11034, February 26, 1979); and
3. Will not have a significant economic impact, positive or
negative, on a substantial number of small entities under the criteria
of the Regulatory Flexibility Act.
We prepared a regulatory evaluation of the estimated costs to
comply with this AD and placed it in the AD docket.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by
reference, Safety.
Adoption of the Amendment
0
Accordingly, under the authority delegated to me by the Administrator,
[[Page 2179]]
the FAA amends 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES
0
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
0
2. The FAA amends Sec. 39.13 by adding the following new AD:
2007-02-01 Dassault Aviation: Amendment 39-14888. Docket No. FAA-
2007-26855; Directorate Identifier 2006-NM-264-AD.
Effective Date
(a) This airworthiness directive (AD) becomes effective February
2, 2007.
Affected ADs
(b) None.
Applicability
(c) This AD applies to Dassault Model Falcon 2000EX airplanes;
s/n (serial number) 06, s/n 28 through 90, s/n 93, and s/n 95;
certificated in any category.
Reason
(d) The MCAI states that troubleshooting of a ``ENG 1 FIRE
DETECT FAIL'' CAS (crew alerting system) message that occurred on an
in-service aircraft revealed that the detector threshold tolerances
could not identify a single failure of one engine fire detector loop
out of the two present on each engine. The fire detection system is
therefore not correctly monitored, and its integrity is not
guaranteed at all times. The goal of the MCAI is to verify the fire
detection system integrity by mandating a one-time inspection and,
in case of findings, to replace the faulty detector pending further
modification of the monitoring system. The MCAI will be revised/
superseded once the terminating corrective action for the monitoring
function has been approved.
Actions and Compliance
(e) Unless already done, do the following actions. Within 35
days after the effective date of this AD, perform an engine fire
detection integrity check as required by paragraphs (e)(1), (e)(2),
and (e)(3) of this AD in accordance with Dassault Service Bulletin
F2000EX-137, Revision 1, dated December 7, 2006.
(1) First, in the baggage compartment, on each mobile connector
of the monitoring units (L320WG) and (R320WG), the equivalent
resistance of the two engine detectors at the LH (left-hand) and the
RH (right-hand) sides must be verified. According to findings, the
corresponding system is either considered correct or incorrect.
(2) As a second step, if either one or both the LH and the RH
system is (are) found to be incorrect, it is required to check the
actual resistance of both detectors of the incorrect system(s) on
the affected engine(s).
(3) Any faulty detector must be replaced prior to further
flight.
(4) Actions done before the effective date of this AD in
accordance with Dassault Service Bulletin F2000EX-137, dated
November 23, 2006, are acceptable for compliance with the
requirements of paragraph (e) of this AD.
Other FAA AD Provisions
(f) The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager,
International Branch, ANM-116, Transport Airplane Directorate, FAA,
ATTN: Tom Rodriguez, 1601 Lind Avenue, SW., Renton, Washington
98057-3356, has the authority to approve AMOCs for this AD, if
requested using the procedures found in 14 CFR 39.19.
(2) Airworthy Product: For any requirement in this AD to obtain
corrective actions from a manufacturer or other source, use these
actions if they are FAA-approved. Corrective actions are considered
FAA-approved if they are approved by the State of Design Authority
(or their delegated agent). You are required to assure the product
is airworthy before it is returned to service.
(3) Reporting Requirements: For any reporting requirement in
this AD, under the provisions of the Paperwork Reduction Act, the
Office of Management and Budget (OMB) has approved the information
collection requirements and has assigned OMB Control Number 2120-
0056.
Related Information
(g) Refer to MCAI European Aviation Safety Agency (EASA)
Emergency Airworthiness Directive 2006-0356-E, dated November 30,
2006; and Dassault Service Bulletin F2000EX-137, dated November 23,
2006; or Revision 1, dated December 7, 2006; for related
information.
Material Incorporated by Reference
(h) You must use Dassault Service Bulletin F2000EX-137, Revision
1, dated December 7, 2006, to do the actions required by this AD,
unless the AD specifies otherwise.
(1) The Director of the Federal Register approved the
incorporation by reference of this service information under 5
U.S.C. 552(a) and 1 CFR part 51.
(2) For service information identified in this AD, contact
Dassault Falcon Jet, P.O. Box 2000, South Hackensack, New Jersey
07606.
(3) You may review copies at the FAA, Transport Airplane
Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the
National Archives and Records Administration (NARA). For information
on the availability of this material at NARA, call 202-741-6030, or
go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html
.
Issued in Renton, Washington, on January 5, 2007.
Ali Bahrami,
Manager, Transport Airplane Directorate, Aircraft Certification
Service.
[FR Doc. E7-490 Filed 1-17-07; 8:45 am]
BILLING CODE 4910-13-P