[Federal Register: October 26, 2005 (Volume 70, Number 206)]
[Notices]
[Page 61810-61811]
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
[DOCID:fr26oc05-80]
-----------------------------------------------------------------------
ENVIRONMENTAL PROTECTION AGENCY
[OAR-2005-0084; FRL-7988-6]
Agency Information Collection Activities: Submission to OMB for
Review and Approval; Comment Request; National Emission Standards for
Hazardous Air Pollutants From Plating and Polishing Operations, EPA ICR
Number 2186.01
AGENCY: Environmental Protection Agency.
ACTION: Notice.
-----------------------------------------------------------------------
SUMMARY: In compliance with the Paperwork Reduction Act (44 U.S.C. 3501
et seq.), this document announces that an Information Collection
Request (ICR) has been forwarded to the Office of Management and Budget
(OMB) for review and approval. This is a request for a new collection.
This ICR describes the nature of the information collection and its
estimated burden.
DATES: Comments must be submitted on or before November 25, 2005.
ADDRESSES: Submit your comments, referencing Docket ID number OAR-2005-
0084, to (1) EPA online using EDOCKET (our preferred method), by e-mail
to a-and-r-docket@epa.gov, or by mail to: Environmental Protection
Agency, EPA Docket Center (EPA/DC),
[[Page 61811]]
Air and Radiation Docket and Information Center, Mailcode 6102T, 1200
Pennsylvania Avenue NW., Washington, DC 20460, and (2) OMB at: Office
of Information and Regulatory Affairs, Office of Management and Budget
(OMB), Attention: Desk Officer for EPA, 725 17th Street, NW.,
Washington, DC 20503.
FOR FURTHER INFORMATION CONTACT: Donna Lee Jones, Emission Standards
Division, Office of Air Quality Planning and Standards, U.S.
Environmental Protection Agency (C439-02), Research Triangle Park,
North Carolina, 27711; telephone number: (919) 541-5251; fax number:
(919) 541-3207; e-mail address: jones.donnalee@epa.gov.
SUPPLEMENTARY INFORMATION: The EPA has submitted the following ICR to
OMB for review and approval according to the procedures prescribed in 5
CFR 1320.12. On July 29, 2005 (70 FR 43865), EPA sought comments on
this ICR pursuant to 5 CFR 1320.8(d). EPA received no comments.
The EPA has established a public docket for this ICR under Docket
ID number OAR-2005-0084, which is available for public viewing at the
Air and Radiation Docket and Information Center in the EPA Docket
Center (EPA/DC), EPA West, Room B102, 1301 Constitution Avenue, NW.,
Washington, DC 20460. The EPA Docket Center Public Reading Room is open
from 8:30 a.m. to 4:30 p.m., Monday through Friday, excluding legal
holidays. The telephone number for the Public Reading Room is (202)
566-1744, and the telephone number for the Air and Radiation Docket and
Information Center is (202) 566-1742. An electronic version of the
public docket is available through EPA Dockets (EDOCKET) at http://www.epa.gov/edocket.
Use EDOCKET to obtain a copy of the draft
collection of information, submit or view public comments, access the
index listing the contents of the public docket, and to access those
documents in the public docket that are available electronically. Once
in the system, select ``search,'' then key in the docket ID number
identified above.
Any comments related to this ICR should be submitted to EPA within
30 days of this notice. The EPA's policy is that public comments,
whether submitted electronically or on paper, will be made available
for public viewing in EDOCKET as EPA receives them and without change,
unless the comment contains copyrighted material, confidential business
information (CBI), or other information whose public disclosure is
restricted by statute. When EPA identifies a comment containing
copyrighted information, EPA will provide a reference to that material
in the version of the comment that is placed in EDOCKET. The entire
printed comment, including the copyrighted material, will be available
in the public docket. Although identified as an item in the official
docket, information claimed as CBI, or whose disclosure is otherwise
restricted by statute, is not included in the official public docket,
and will not be available for public viewing in EDOCKET. For further
information about the electronic docket, see EPA's Federal Register
notice at 67 FR 38102 (May 31, 2002), or go to http://www.epa.gov/edocket
.
Title: National Emission Standards for Hazardous Air Pollutants
from Plating and Polishing Operations.
Abstract: The proposed ICR will collect information and data from
1,208 existing plating and polishing facilities. Facilities will be
requested to complete a simple paper questionnaire on general facility
information (location, description, types of processes performed,
operating hours, technical contact), HAP emissions and permit data,
permit conditions, emission tests data, process design and operating
data, HAP-containing material data, finished product types, local
ventilation system information, HAP emission control measures, and
pollution prevention practices. The questionnaire may be completed from
readily available information; no additional emission testing or
monitoring will be required.
The EPA will use the collected information and data to evaluate the
need for area source National Emission Standards for Hazardous Air
Pollutants (NESHAP) required under section 112(k) of the Clean Air Act
for the Plating and Polishing Area Source Category. If an area source
NESHAP is developed, the collected information will be used to evaluate
the types of provisions needed to limit HAP emissions from plating and
polishing operations and to estimate the impacts of regulatory options.
The EPA's authority to collect information is contained in Section
114 of the Clean Air Act, (42 U.S.C 7414). All information submitted to
EPA pursuant to this ICR for which a claim of confidentiality is made
is safeguarded according to Agency policies in 40 CFR part 2, subpart
B. An agency may not conduct or sponsor, and a person is not required
to respond to, a collection of information unless it displays a
currently valid OMB control number. The OMB control numbers for EPA's
regulations in 40 CFR are listed in 40 CFR part 9 and are identified on
the form and/or instrument, if applicable.
Burden Statement: The annual public reporting and recordkeeping
burden for this collection of information is estimated to average 12.1
hours per response. Burden means the total time, effort, or financial
resources expended by persons to generate, maintain, retain, or
disclose or provide information to or for a Federal agency. This
includes the time needed to review instructions; develop, acquire,
install, and utilize technology and systems for the purposes of
collecting, validating, and verifying information, processing and
maintaining information, and disclosing and providing information;
adjust the existing ways to comply with any previously applicable
instructions and requirements; train personnel to be able to respond to
a collection of information; search data sources; complete and review
the collection of information; and transmit or otherwise disclose the
information.
Respondents/Affected Entities: Entities potentially affected by
this action are establishments primarily engaged in all types of
electroplating, electroless plating, metal or thermal spraying,
anodizing, coloring, and finishing of metals and formed products for
the trade. Also potentially affected by this action are establishments
which perform these types of activities, on their own account, on
purchased metals or formed products. The standard industrial
classification (SIC) code for this industry is primarily 3471,
Electroplating, Plating, Polishing, Anodizing, and Coloring; the North
American Industry Classification System (NAICS) code is 332813,
Electroplating, Plating, Polishing, Anodizing, and Coloring.
Estimated Number of Respondents: 1,208.
Frequency of Response: This is a new collection requiring a one-
time response.
Estimated Total Annual Hour Burden: 5,608 hours.
Estimated Total Annual Cost: $366,566, which includes $0 annual
capital/startup costs, $0 annual O&M costs, and $366,566 annual labor
costs.
Changes in the Estimates: This section does not apply since this is
a new collection.
Dated: October 18, 2005.
Sara Hisel-McCoy,
Acting Director, Collection Strategies Division.
[FR Doc. 05-21371 Filed 10-25-05; 8:45 am]
BILLING CODE 6560-50-P