Site preparation for an oil and gas well, in most instances, looks like
any other construction site. OSHA uses Safety
and Health Regulations for Construction [1926]
to assess safety compliance during this phase of the
development of a drilling site.
Once the location for the site has been established, the area is prepared for
drilling, with the following steps:
|
Fig. 1. Clearing the drilling site
|
Leveling Site |
The site is leveled (if necessary) with a bulldozer and/or a grader.
Potential Hazards:
Fig. 2. Leveling uneven ground
|
- Damaging buried pipelines and cables.
- Unpredictable weather changes can create unexpected hazards.
- Irritant and toxic plants, pollens, and other entrained
materials.
- Uneven ground may cause bulldozers to roll over.
Possible Solutions:
- Perform a site line location survey.
- Plan for hazards due to unpredictable changing weather.
- After weather changes, conduct inspections for new hazards.
- Protect employees engaged in site clearing from hazards of irritant and toxic plants. Teach the
employees about available first aid treatments. [1926.604(a)(1)]
- Provide rollover guards on all equipment used in site clearing
operations. [1926.602]
- Provide overhead and rear canopy guards on rider-operated equipment. [1926.604(a)(2)]
|
Excavating and Trenching |
Fig. 3. Reserve pit
Fig. 4. Excavating at a drill site
|
The scale and duration of excavating and trenching are very minor and site-specific. On some drilling sites, a
below-ground-level cellar may be excavated. This is where the main borehole is to be drilled. A reserve pit and settling pits may be excavated and are used for water or drilling fluid (mud)
discharges.
Potential Hazards:
- Dust and other airborne contaminants can cause respiratory problems or allergic reactions.
- Damaging buried pipelines and cables.
Possible Solutions:
- Wear appropriate respiratory protection. [1910.134]
- Perform a site line location survey.
|
|
|