[Code of Federal Regulations] [Title 40, Volume 22] [Revised as of July 1, 2004] From the U.S. Government Printing Office via GPO Access [CITE: 40CFR180.501] [Page 483] TITLE 40--PROTECTION OF ENVIRONMENT CHAPTER I--ENVIRONMENTAL PROTECTION AGENCY (CONTINUED) PART 180_TOLERANCES AND EXEMPTIONS FROM TOLERANCES FOR PESTICIDE CHEMICALS IN FOOD--Table of Contents Subpart C_Specific Tolerances Sec. 180.501 Hydroprene; tolerances for residues. (a) General. A tolerance of 0.2 part per million is established for residues of hydroprene [(S)-(Ethyl (2E,4E,7S)-3,7,11-trimrthyl-2,4- dodecadienoate)], (CAS Reg. No. 65733-18-8) on all food items in food- handling establishments in accordance with the following prescribed conditions: (1) Application shall be limited to spot, crack and crevice, perimeter and ultra low volume (ULV) fogging treatment in food storage or food-handling establishments, including warehouses, food service, manufacturing, and processing establishments such as restaurants, cafeterias, supermarkets, bakeries, breweries, dairies, meat slaughtering and packing plants, and canneries where food and food products are held, processed, and served: Provided that the food is removed or covered prior to such use, and food-processing surfaces are covered during treatment or thoroughly cleaned before using, or in the case of point-source device treatments, devices must not come into direct contact with food preparation surfaces and must be in a minimum distance of 3 feet from exposed foods. (2) To assure safe use of the insect growth regulator, the label and labeling shall conform to that registered by the U.S. Environmental Protection Agency, and it shall be used in accordance with such label and labeling. (b) Section 18 emergency exemptions. [Reserved] (c) Tolerances with regional registrations. [Reserved] (d) Indirect or inadvertent residues. [Reserved] [62 FR 61647, Nov. 19, 1997]