[Code of Federal Regulations] [Title 40, Volume 27] [Revised as ofJuly 1, 2003] From the U.S. Government Printing Office via GPO Access [CITE: 40CFR428.86] [Page 77-78] TITLE 40--PROTECTION OF ENVIRONMENT CHAPTER I--ENVIRONMENTAL PROTECTION AGENCY (CONTINUED) PART 428--RUBBER MANUFACTURING POINT SOURCE CATEGORY--Table of Contents Subpart H--Wet Digestion Reclaimed Rubber Subcategory Sec. 428.86 Pretreatment standards for new sources. Any new source subject to this subpart that introduces process wastewater pollutants into a publicly owned treatment works must comply with 40 CFR part 403. In addition, the following pretreatment standard establishes the quantity or quality of pollutants or [[Page 78]] pollutant properties, controlled by this section, which may be discharged to a publicly owned treatment works by a new point source subject to the provisions of this subpart: ------------------------------------------------------------------------ Pretreatment standards ----------------------------- Average of daily Pollutant or pollutant property Maximum values for 30 for any 1 consecutive days day shall not exceed- - ------------------------------------------------------------------------ Metric units (kg/kkg of product) ------------- COD....................................... 14.7 6.11 Oil and grease............................ (\1\) (\1\) TSS....................................... (\2\) (\2\) pH........................................ (\2\) (\2\) ------------- English units (lb/1,000 lb of product) ------------- COD....................................... 14.7 6.11 Oil and grease............................ (\1\) (\1\) TSS....................................... (\2\) (\2\) pH........................................ (\2\) (\2\) ------------------------------------------------------------------------ \1\ 100 mg/l. \2\ No limitation. [40 FR 2341, Jan. 10, 1975, as amended at 60 FR 33964, June 29, 1995]