![]() |
U.S. Department of Labor | ![]() |
||||
Occupational Safety & Health Administration |
![]() |
Standard Interpretations
08/31/1993 - Employee exposure to hazardous chemicals while working around small sensors. |
![]() |
Standard Number: | 1910.1200 |
August 31, 1993
Ms. Denese A. Deeds, CIH Dear Ms. Deeds: This is in response to your letter of June 21, to Mr. John Miles concerning the Occupational Safety and Health Administration's (OSHA) Hazard Communication Standard, 29 CFR 1910.1200. Mr. Miles forwarded your inquiry to the Office of Health Compliance Assistance for response. Please accept our apologies for the delay in responding to your letter. You explain that employees working with or around small sensors which contain small amounts of corrosive chemicals would not be exposed to the hazardous chemicals under "normal conditions of use." OSHA agrees that these sensors would be considered articles as long as employees were not exposed to the hazardous chemicals, and, therefore, would not be covered by the Hazard Communication Standard (HCS). If employees were exposed to the hazardous chemicals contained in the sensors during the construction of scientific instruments, or during the removal and disposal of old sensors, the HCS would apply. It is the employer's responsibility to determine if there is a threat of exposure to hazardous chemicals. OSHA instruction CPL 2-2.38C, dated October 22 1990, states the following in paragraph K.3.c.: In some cases, a hazardous chemical may be present for a long period of time without an employee exposure until repair or demolition activities are performed. By way of example, employers involved in work operations where jackhammers are being used to break up a sidewalk know that they are exposing their employees to a hazardous chemical (silica), even though they did not "bring" the hazard to the site. Even though other provisions of the standard may not be enforceable (MSDS and labels), the employer should still develop a hazard communication program to inform their employees "about the hazardous chemicals to which they are exposed." Employers may utilize their already existing hazard communication program to communicate information on these types of hazards to their employees, as per paragraph (e)(3). If there is potential for employee exposure, employers are required to include information regarding the hazards of the corrosive materials in the sensors in their hazard communication program. We hope this information is helpful. If you have any further questions please contact the Office of Health Compliance Assistance at (202) 219-8036.
Sincerely,
|
![]() |
![]() |
www.osha.gov | www.dol.gov |
Contact Us | Freedom of Information Act | Customer Survey Privacy and Security Statement | Disclaimers |
||
Occupational Safety & Health Administration 200 Constitution Avenue, NW Washington, DC 20210 |