By Gregory P. Stanton, Wade Kress, Christopher M. Hobza, and John B. Czarnecki
This
document is available in Portable Document Format (PDF): WRIR03-4292 (2.75 MB)
To view this document, you need the Adobe Acrobat® Reader installed on
your computer.
(A free
copy of the Acrobat® Reader may be downloaded from Adobe Systems
Incorporated.)
A surface-geophysical investigation of the Red River Aluminum site at Stamps, Arkansas, was conducted in cooperation with the Arkansas Department of Environmental Quality to determine
the possible extent and depth of saltwater contamination. Water-level measurements indicate the distance to water level below land surface ranges from about 1.2 to 3.9 feet (0.37 to 1.19 meters) in shallow monitor wells and about 10.5 to 17.1 feet (3.20 to 5.21 meters) in deeper monitoring
wells. The two-dimensional, direct-current resistivity method identified resistivities less than 5 ohm-meters which indicated possible areas of salt contamination occurring in near-surface or deep subsurface ground water along four resistivity
lines within the site. One line located east of the site yielded data that demonstrated no effect of salt contamination. Sections from two of the five data sets were modeled. The input model grids were created on the basis of the known geology and the results and interpretations of borehole geophysical data. The clay-rich Cook Mountain Formation is modeled as 25 ohm-meters and extends from 21 meters (68.9 feet) below land surface to the bottom of the model (about 52 meters (170.6 feet)). The models were used to refine interpretation of the resistivity data and to determine extent of saltwater contamination and depth to the Cook Mountain Formation.
Data from the resistivity lines indicate both near-surface and subsurface saltwater contamination.
The near-surface contamination appears as low resistivity (less than 5 ohm-meters) on four of the five resistivity lines, extending up to 775 meters (2,542.8 feet) horizontally in a line that traverses the entire site south to north. Model resistivity
data indicate that the total depth of saltwater contamination is about 18 meters (59 feet) below land surface. Data from four resistivity lines identified
areas containing low resistivity anomalies interpreted as possible salt contamination. A fifth line located just east of the site showed no saltwater
contamination.
TABLE OF CONTENTS
AccessibilityFOIAPrivacyPolicies and Notices | |
U.S. Department of the Interior, U.S. Geological Survey
Persistent URL: http://pubs.water.usgs.gov/wri034292 Page Contact Information: Publishing Service Center Last modified: Thursday, September 01 2005, 05:07:35 PM |