[Code of Federal Regulations] [Title 48, Volume 1] [Revised as of October 1, 2002] From the U.S. Government Printing Office via GPO Access [CITE: 48CFR16.504] [Page 310-312] TITLE 48--FEDERAL ACQUISITION REGULATIONS SYSTEM CHAPTER 1--FEDERAL ACQUISITION REGULATION PART 16--TYPES OF CONTRACTS--Table of Contents Subpart 16.5--Indefinite-Delivery Contracts Sec. 16.504 Indefinite-quantity contracts. (a) Description. An indefinite-quantity contract provides for an indefinite quantity, within stated limits, of supplies or services during a fixed period. The Government places orders for individual requirements. Quantity limits may be stated as number of units or as dollar values. (1) The contract must require the Government to order and the contractor to furnish at least a stated minimum quantity of supplies or services. In addition, if ordered, the contractor must furnish any additional quantities, not to exceed the stated maximum. The contracting officer should establish a reasonable maximum quantity based on market research, trends on recent contracts for similar supplies or services, survey of potential users, or any other rational basis. (2) To ensure that the contract is binding, the minimum quantity must be more than a nominal quantity, but it should not exceed the amount that the Government is fairly certain to order. (3) The contract may also specify maximum or minimum quantities that the Government may order under each task or delivery order and the maximum that it may order during a specific period of time. (4) A solicitation and contract for an indefinite quantity must-- (i) Specify the period of the contract, including the number of options and the period for which the Government may extend the contract under each option; (ii) Specify the total minimum and maximum quantity of supplies or services the Government will acquire under the contract; (iii) Include a statement of work, specifications, or other description, that reasonably describes the general scope, nature, complexity, and purpose of the supplies or services the Government will acquire under the contract in a manner that will enable a prospective offeror to decide whether to submit an offer; (iv) State the procedures that the Government will use in issuing orders, including the ordering media, and, if multiple awards may be made, state the procedures and selection criteria that the Government will use to provide awardees a fair opportunity to be considered for each order (see 16.505(b)(1)); (v) Include the name, address, telephone number, facsimile number, and e-mail address of the agency task and delivery order ombudsman (see 16.505(b)(5)) if multiple awards may be made; [[Page 311]] (vi) Include a description of the activities authorized to issue orders; and (vii) Include authorization for placing oral orders, if appropriate, provided that the Government has established procedures for obligating funds and that oral orders are confirmed in writing. (b) Application. Contracting officers may use an indefinite-quantity contract when the Government cannot predetermine, above a specified minimum, the precise quantities of supplies or services that the Government will require during the contract period, and it is inadvisable for the Government to commit itself for more than a minimum quantity. The contracting officer should use an indefinite-quantity contract only when a recurring need is anticipated. (c) Multiple award preference--(1) Planning the acquisition. (i) Except for indefinite-quantity contracts for advisory and assistance services as provided in paragraph (c)(2) of this section, the contracting officer must, to the maximum extent practicable, give preference to making multiple awards of indefinite-quantity contracts under a single solicitation for the same or similar supplies or services to two or more sources. (ii)(A) The contracting officer must determine whether multiple awards are appropriate as part of acquisition planning. The contracting officer must avoid situations in which awardees specialize exclusively in one or a few areas within the statement of work, thus creating the likelihood that orders in those areas will be awarded on a sole-source basis; however, each awardee need not be capable of performing every requirement as well as any other awardee under the contracts. The contracting officer should consider the following when determining the number of contracts to be awarded: (1) The scope and complexity of the contract requirement. (2) The expected duration and frequency of task or delivery orders. (3) The mix of resources a contractor must have to perform expected task or delivery order requirements. (4) The ability to maintain competition among the awardees throughout the contracts' period of performance. (B) The contracting officer must not use the multiple award approach if-- (1) Only one contractor is capable of providing performance at the level of quality required because the supplies or services are unique or highly specialized; (2) Based on the contracting officer's knowledge of the market, more favorable terms and conditions, including pricing, will be provided if a single award is made; (3) The expected cost of administration of multiple contracts outweighs the expected benefits of making multiple awards; (4) The projected orders are so integrally related that only a single contractor can reasonably perform the work; (5) The total estimated value of the contract is less than the simplified acquisition threshold; or (6) Multiple awards would not be in the best interests of the Government. (C) The contracting officer must document the decision whether or not to use multiple awards in the acquisition plan or contract file. The contracting officer may determine that a class of acquisitions is not appropriate for multiple awards (see subpart 1.7). (2) Contracts for advisory and assistance services. (i) Except as provided in paragraph (c)(2)(ii) of this section, if an indefinite- quantity contract for advisory and assistance services exceeds 3 years and $10 million, including all options, the contracting officer must make multiple awards unless-- (A) The contracting officer or other official designated by the head of the agency determines in writing, as part of acquisition planning, that multiple awards are not practicable. The contracting officer or other official must determine that only one contractor can reasonably perform the work because either the scope of work is unique or highly specialized or the tasks so integrally related; (B) The contracting officer or other official designated by the head of the agency determines in writing, after the evaluation of offers, that only one offeror is capable of providing the services required at the level of quality required; or (C) Only one offer is received. [[Page 312]] (ii) The requirements of paragraph (c)(2)(i) of this section do not apply if the contracting officer or other official designated by the head of the agency determines that the advisory and assistance services are incidental and not a significant component of the contract. [65 FR 24318, Apr. 25, 2000]