publications >
fact sheet >
FS-173-96
U.S. Department of the Interior Geophysical Mapping of the Freshwater/Saltwater Interface in Everglades National Park, Florida
Background Water quality in Everglades National Park (ENP) and the discharge of fresh water into Florida Bay are influenced by water use and management policies in South Florida. The flow of fresh water through the Everglades into Florida Bay is critical to the well being of the South Florida Ecosystem (SFE). Restoration activities by Federal agencies are aimed at mitigating the effect of increased demand for water, farming, and flood control practices in South Florida on the SFE. Assessing the effectiveness of restoration efforts is difficult because of inaccessibility of much of this area. Airborne geophysical methods provide a means of rapidly and economically monitoring large areas where ground access is difficult. Geophysical Measurement of Water Quality The ability of materials to conduct electricity is called electrical conductivity, which in geologic materials is controlled primarily by the amount of pore space in the rock and the salinity of the water in the pore space. Increasing the pore space or salinity increases the electrical conductivity, while decreasing these quantities has the opposite effect. The conductivity of water, which is controlled by the concentration of dissolved ions, shows how well the water conducts electricity. For example, fresh water found in the ENP typically has a chloride ion concentration of 40 mg/L and a specific conductivity (SC) of 0.450 mS/cm. Saline water found in Florida Bay has chloride levels of 15,000-35,000 mg/L and an SC of 20-50 mS/cm (fig. 1). This one-hundred-fold difference in SC can produce a similar difference in the conductivity of geologic materials saturated with fresh or saline water. In our study of the Everglades several EM methods are being used to map the location of the freshwater/saltwater interface. These methods include helicopter electromagnetics (HEM), borehole induction logging, and time-domain electromagnetic soundings (TEM), which are discussed below. Helicopter Electromagnetic Resistivity Mapping HEM resistivity mapping makes use of an instrument pod, called a "bird," which is slung below a helicopter (fig. 2). The bird contains pairs of transmitter and receiver coils which measure the electromagnetic response of the ground at different frequencies to obtain information from different depths. The bird is flown back and forth over the survey area along parallel lines about 400 m (1/4 mi) apart. The raw data are processed to produce apparent resistivity maps such as the one shown on figure 3. By interpreting the apparent resistivity maps from different frequencies, information about how resistivity varies with depth can be determined. The apparent resistivity map shows several interesting features including the prominent transition from higher resistivities in the landward direction to lower resistivities toward the shore. This feature is the freshwater/saltwater interface (FWSWI) and is marked on figure 3. In the region of Shark River Slough the FWSWI follows the terminus of rivers that have tidal flow. Taylor Slough, one of the primary sources of water for Florida Bay, shows up as a resistive feature. The influence of manmade features is seen where the FWSWI crosses the C-111 canal where a control structure on the canal produces a distortion in the interface. A conductive feature is seen along the old Ingraham Highway where saline water flowed inland in the canal adjacent to the highway. Borehole and Surface Geophysical Measurements To refine the interpretation of the airborne geophysical data, we rely on borehole and surface geophysical measurements, and water quality samples. Figure 4 shows an induction log and time-domain electromagnetic (TEM) sounding from near the FWSWI. The induction log, which is measured with a tool lowered into a well, provides detailed information on how resistivity varies with depth near the well. The TEM sounding, which is a surface measurement, also gives information on resistivity-depth variations. The transition from high resistivity surface water to low resistivity saline water is seen in both measurements at a depth of 10 m, and has been confirmed by water-quality data. Repeat borehole logs are being made to monitor seasonal and long-term changes. Monitoring of Restoration Activity Repeat HEM surveys have been made at the end of the dry and rainy seasons. Comparison of these results show that there are significant changes associated with increased fresh-water flows during the wet season. This result indicates that periodic repeat HEM surveys can be used to monitor changes in the ground-water system caused by restoration activity such as increasing flows of fresh water into Taylor Slough. Plan of Study Additional airborne surveys are planned. These and other geophysical data will be used for restoration monitoring and development of ground-water models. Product Plans:
Anticipated Schedule
Click here for a printable version of this fact sheet (note: document will
open in a new browser window)
For more information contact:
Related information:
|
U.S. Department of the Interior, U.S. Geological Survey
This page is: http://sofia.usgs.gov/publications/fs/173-96/index.html
Comments and suggestions? Contact: Heather Henkel - Webmaster
Last updated: 04 November, 2004 @ 02:13 PM(TJE)