CPM 2001-3
|
|
United States Office of Personnel Management |
February 15, 2001
|
MEMORANDUM FOR HUMAN RESOURCES DIRECTORS (CPM 2001-3) | |
|
FROM: |
HENRY ROMERO |
SUBJECT: |
Calculating Rates of Basic Pay for Certain GM Employees Who Receive Special Salary Rates |
Agency human resources officials have called our attention to a problem involving the calculation of the underlying rates of basic pay (and the corresponding locality rates of pay) for a small number of GM employees. The only employees potentially affected by this problem are employees at grades GM-13, 14, and 15 who are covered by special rate table 0558 (Air Force Reserves and Air National Guard pilots) and employees at grade GM-13 who are covered by special rate tables 999B-F (information technology workers). This memorandum provides guidance on how to calculate pay rates correctly for this small group of employees.
Background
GM employees are employed only at grades 13 through 15 of the General Schedule (GS). They were covered by the Performance Management and Recognition System when it was terminated in 1993, and they remain covered by the GM pay plan code. (See 5 CFR 531.202 and 531.203(g).) As GM employees, their rate of basic pay does not have to be set at one of the fixed step rates for their grade, but may be set at any dollar rate. The Office of Personnel Management's (OPM's) regulations provide detailed rules for applying the annual across-the-board GS pay increase to GM rates. (See 5 CFR 531.205(a)(2).) These rules are designed to ensure that the employee's new GM rate retains the same relative position in the rate range as the old GM rate.
GM employees may be covered by special salary rates. When a special rate schedule is established or increased, GM employees' new special rates are calculated under the same rules used to apply the annual across-the-board GS pay increase. (See 5 CFR 531.306(a)(3), which requires use of the rules in 5 CFR 531.205(a)(2).)
Under the traditional approach for designing special rate schedules, a fixed dollar amount is added to each GS step rate of the grade for which special rates are established. Thus, the special rate schedule is built using the same within-grade increase dollar amounts as the regular General Schedule. In contrast, the special rate schedules cited above were constructed by increasing each GS step rate by a fixed percentage (parallel to the way locality payments are calculated). This means that the within-grade increases in these special rate schedules are larger than the regular GS within-grade increases for the corresponding GS grade. As a result, the rate range for each grade under these special rate schedules is larger (in dollar terms) than the rate range for the corresponding GS grade.
The Problem
For GM employees who are receiving special rates, the GM rate of basic pay is used only for limited purposes, such as calculating locality payments and applying the maximum payable rate rule. For locality pay and law enforcement officer (LEO) geographic adjustment purposes, the rate of basic pay used to calculate locality and LEO geographic payments is referred to as a "scheduled annual rate of pay." (See 5 CFR 531.602 and 531.301.) OPM regulations provide that the scheduled annual rate of pay for GM employees is calculated by (1) finding the difference between the employee's GM special rate and the step 1 special rate for the applicable grade and (2) adding that difference to the step 1 GS rate for the applicable grade.
In most cases, this rule works perfectly well as a shortcut method for determining an employee's new GM rate of basic pay without having to follow the more detailed method prescribed in 5 CFR 531.205(a)(2). This shortcut, however, was designed specifically for special rate schedules constructed by using the traditional fixed-dollar within-grade increase approach. The shortcut method therefore does not provide the correct GM rate of basic pay when the employee is covered by a special rate schedule for which the special rates were set by increasing the GS rates by a fixed percentage amount at each grade. If your payroll system relied on this shortcut method for GM employees under tables 0558 and 999B-F, it will have generated an incorrect GM rate of basic pay and incorrect locality or LEO geographic payments. These incorrect rates will be higher than the correct rates. In the case of a GM employee at step 10, for example, the incorrect rates would exceed the maximum GS and locality rates.
How to Correct the Problem
Rates constructed by using the shortcut method must be corrected. We encourage agencies to make appropriate use of their waiver authority under 5 U.S.C. 5584 in dealing with any overpayments resulting from use of the shortcut method.
Agencies must calculate the correct GM rate of basic pay for affected employees by using the more detailed method in 5 CFR 531.205(a)(2). For example, in the case of any GM-13 employee covered by the information technology special rates (tables 999B-F), follow the following steps to apply the detailed method and compute the correct GM unadjusted rate of basic pay in effect at the beginning of the first pay period in January 2001:
We issued an example of a pay calculation for a GM-13 employee covered by table 999C in an attachment to our December 26, 2000, memorandum for agency human resources directors about the January 2001 pay adjustments (CPM 2000-19). Example 8b followed the shortcut rule and was incorrect. We have attached a corrected example 8b to this memorandum, along with a copy of the original example 8a.
We sincerely apologize for any confusion caused by our failure to identify this problem sooner. Please let us know if we can provide any assistance to you in calculating the appropriate rate of pay for any affected employee. You may contact our Pay and Leave Administration Division by calling (202) 606-2858 or by email at payleave@opm.gov.
Web page created 15 February 2001