Department of Labor Seal photos representing the workforce - digital imagery© copyright 2001 photodisc, inc.
Department of Labor Seal www.osha.gov  [skip navigational links] Search    Advanced Search | A-Z Index
Metalworking Fluids Metalworking Fluids
OSHA Standards

Hazards related to metalworking fluids (MWFs) are addressed in specific standards for the general industry, shipyard employment, and the construction industry. This page highlights OSHA standards and standard interpretations (official letters of interpretation of the standards) related to MWFs.

Section 5(a)(1) of the OSH Act, often referred to as the General Duty Clause, requires employers to "furnish to each of his employees employment and a place of employment which are free from recognized hazards that are causing or are likely to cause death or serious physical harm to his employees". Section 5(a)(2) requires employers to "comply with occupational safety and health standards promulgated under this Act".

Note: Twenty-four states, Puerto Rico and the Virgin Islands have OSHA-approved State Plans and have adopted their own standards and enforcement policies. For the most part, these States adopt standards that are identical to Federal OSHA. However, some States have adopted different standards applicable to this topic or may have different enforcement policies.

Highlighted Standards

General Industry (29 CFR 1910)

  • 1910 Subpart Z, Toxic and hazardous substances [related topic page]
    • 1910.1000, Air contaminants
      • Table Z-1, Limits for air contaminants
        • Oil Mist, mineral: 5 mg/m³
        • Particulates not otherwise regulated, total dust: 15 mg/m³
        • Particulates not otherwise regulated (PNOR), respirable fraction: 5 mg/m³

Shipyard Employment (29 CFR 1915)

  • 1915 Subpart Z, Toxic and hazardous substances
    • 1915.1000, Air contaminants
      • Oil Mist, mineral: 5 mg/m³
      • Particulates not otherwise regulated (PNOR), total dust organic and inorganic: 15 mg/m³

Construction Industry (29 CFR 1926)

  • 1926 Subpart D, Occupational health and environmental controls
    • 1926.55, Gases, vapors, fumes, dusts, and mists
      • Appendix A, Gases, vapors, fumes, dusts, and mists
        • Oil Mist, mineral: 5 mg/m³
        • Particulates not otherwise regulated (PNOR), total dust organic and inorganic: 15 mg/m³

Standard Interpretations


 Safety and
 Health Topics
 
  Metalworking Fluids
  OSHA Standards
  Health Effects
  Evaluation and Controls
  Additional
Information
  Credits
 
Content Reviewed 08/01/2007
 
 

 
Back to TopBack to Top www.osha.gov www.dol.gov

Contact Us | Freedom of Information Act | Customer Survey
Privacy and Security Statement | Disclaimers
Occupational Safety & Health Administration
200 Constitution Avenue, NW
Washington, DC 20210
Page last updated: 08/01/2007