This map of Maryland shows the wind resource at 50 meters.
The Department of Energy's Wind Program and the National Renewable Energy Laboratory (NREL) published a new wind resource map for the state of Maryland . This resource map shows wind speed estimates at 50 meters above the ground and depicts the resource that could be used for utility-scale wind development. Future plans are to provide wind speed estimates at 30 meters, which are useful for identifying small wind turbine opportunities.
As a renewable resource, wind is classified according to wind power classes, which are based on typical wind speeds. These classes range from Class 1 (the lowest) to Class 7 (the highest). In general, at 50 meters, wind power Class 4 or higher can be useful for generating wind power with large turbines. Class 4 and above are considered good resources. Particular locations in the Class 3 areas could have higher wind power class values at 80 meters than shown on the 50 meter map because of possible high wind shear. Given the advances in technology, a number of locations in the Class 3 areas may suitable for utility-scale wind development.
This map indicates that Maryland has wind resources consistent with utility-scale production. Several areas of the state are estimated to have good-to-excellent wind resource. These are the barrier islands along the Atlantic coast, the southeastern shore of Chesapeake Bay, and ridge crests in the western part of the state, west of Cumberland.
Note: Wind resource at a micro level can vary significantly; therefore, you should get a
professional evaluation of your specific area of interest.
The sponsor of the Maryland wind map is the Maryland Energy Administration.
If you have a disability and need assistance reading the wind map, please email the Webmaster.
|