Table 6.22 – Door and Gate Surfaces
Current Guidelines:  
No requirement.

Final Revised Guidelines:  
404.1 General.  Doors, doorways, and gates that are part of an accessible route shall comply with 404.

404.2.10 Door and Gate Surface.  Swinging door and gate surfaces within 10 inches (255 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door or gate.  Parts creating horizontal or vertical joints in these surfaces shall be within 1/16 inch (1.6 mm) of the same plane as the other.  Cavities created by added kick plates shall be capped.
Exceptions: . . .
2.  Tempered glass doors without stiles and having a bottom rail or shoe with the top leading edge tapered at 60 degrees minimum from the horizontal shall not be required to meet the 10 inch (255 mm) bottom smooth surface height requirement. . . .
4.  Existing doors and gates without smooth surfaces within 10 inches (255 mm) of the finish floor or ground shall not be required to comply with 404.2.10 provided that if added kick plates are installed, cavities created by such kick plates are capped.

Model Codes & Standards
ICC/ANSI A117.1-1998:  Section 404.2.10 has an equivalent requirement for door and gate surfaces and exception for tempered glass doors without stiles.